Durovin Bathrooms Teramo 22 User manual

Teramo 22 Double Door

Table of Contents
Included Parts....................................................................................................3
Tools Required...................................................................................................4
Aluminium Profile assembly...............................................................................5
Glass door panel assembly ................................................................................8
Apply silicone sealant ......................................................................................11

Included Parts
Ref
Description
Illustrations
Qty
Ref
Description
Illustration
Qty
①
Weather Bar
1
⑦
Screws
8
②
Fixing Pieces
(R/L) 2
⑧
Aluminium Profile
Caps
2
③
Seals
2
⑨
Handles
2
④
Glass Doors
2
⑩
Seals
2
⑤
Aluminium
Profiles
2
⑪
Caps
4
⑥
Plugs
10
⑫
Screws
6

Tools Required
Two people required. We recommend that a technically competent installer should
undertake this installation.
Be sure you have all included parts and tools required before beginning installation and that
you have plenty of space for assembly.
If you have ordered this shower enclosure with one of our shower trays, please note that
tiling should be done before the shower tray is installed. This is so that the shower tray can
be pushed up against the tiles and sealed with silicone.
PRE-INSTALLATION AND TECHNICAL REQUIREMENTS
•All dimensions are shown in millimetres, except where otherwise indicated.
•Ensure that the enclosure set is fitted to a level floor and vertical wall surface.
•This instruction manual is applicable for both pre-tiled wall and plain walls.
•The wall fixings included with this product are suitable for solid walls only. Plasterboard
or stud walls may require specialist fixings (not supplied).
•Due to the possibility of residual spray, the area around the outside of the shower tray
should be tiled, or made otherwise water resistant.
IMPORTANT SAFETY NOTES
•Under no circumstances should you attempt to drill through the glass, damage or injury
may occur
•Please handle all glass with care, avoiding knocks and shock loading to all sides and
edges. Safety glass cannot be reworked.
•Care should be taken when drilling into walls to avoid hidden pipes or electrical cables.

Aluminium Profile assembly
1. Measure how far forwards your shower door will sit.

2. Using a spirit level, place the aluminium profiles against each wall, marking where
holes will be drilled.

3. Drill holes and insert wall plugs.
4. Screw the aluminium profiles onto each wall.

Glass door panel assembly
5. Carefully lift the glass doors, sliding them into the aluminium profiles.

6. Slide seals onto both glass doors.
7. Carefully drill pilot holes into the aluminium profiles, screwing the aluminium profile
onto the profile against the glass door, inserting caps over the screws.
8. Slide the bottom seals onto each glass door.

9. Insert caps on top of both aluminium profiles.
10. Slide fixing pieces into place, marking where holes will be drilled.
11. Drill holes and insert plugs, screwing the fixing pieces into place.
12. Attach weather bar to the fixing pieces.

Apply silicone sealant
13. Attach the handles to the glass doors.
14. Silicone and allow to dry for 24 hours.