Santec EDO 928460 User manual

EDO COLLECTION
PERSONAL SHOWER WITH SLIDE BAR
MODEL: 928460
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
25
1
4
"
57”
water inlet
24.8
"
21
16
"

25
1
4
"
21
16
"
INSTALLATION INSTRUCTIONS
MARKING
1.
- Mark the vertical distance of 24.8" inch on the wall.
-This is the center distance between the two mounting posts.
-Mounting posts for the slide bars are assembled with set screws.
-Disassemble mounting posts by unscrewing the set screw inside the
base body.
-Place the mounting post in the center mark and insert the screws in
each of the 4 holes.
-Tighten them firmly.
ASSEMBLY
1.
- Cylindrical holder for the slide bars are assembled with the bar.
- Put mounting screw through the hole in the base body.
This will go into the hole at the top of the mounting post sub
assembly.
- Firmly tighten it.
- Now slide bar and holder assembly (both ends) on the earlier
installed pedestal in such a way so that this assemble in the two
blind holes in the post.
- Align them in such a way so that mounting spindle locates
in the middle .
928460_ _
PAGE 02
Wall
Wall
Mounting post
Hole in the post for screws
Slide bar grooved end
0.235”
- Put on the Personal hand held spray assembly
in the slotted groove as shown int he gure.
24.8”