Timbertrove Cruagh Dining Set User manual

F. O’Kelly & Son Ltd. T/A Timbertrove | Killakee, Rathfarnham, Dublin 16
01 493 1034 | [email protected] | www.timbertrove.com
Cruagh Dining Set –Assembly Instructions
ASSEMBLING THE TABLE SECTION
1. Firstly, assemble leg sections.
2. Using the end rails, slot into top and bottom of the mortice hole in the
pre-assembled leg section. Fix using 90mm screws through pre-
drilled holes in the leg section repeat for all sides.
3. Now you have assembled the table leg sections, place the table top
upside down on a level surface making sure not to scratch the table
top. Screw down assembled leg section using 90mm screws provided,
making sure there is an even space around table top.
4. Upright table and screw shelf supports into desired position on the
legs at both ends, next fix boards on using 60mm screws provided.
Now fix 485mm table brace through pre-drilled holes using 60mm
screws provided.
List of parts & fixings
----------------------------------------------------------------------------------
1 x Table Top
4 x Seat Tops
2 x Table Leg Sections
8 x Seat Leg Sections
4 x Table Leg End Rails
16 x Seat Braces
2 x Shelf Supports
2 x Shelf Boards
32 x 60mm Green Screws
62 x 90mm Green Screws
When assembling, loosely fix together until fully assembled then tighten all
the fixings.
We recommend gluing all mortice and tenon joints before fully assembling. (Glue
not provided)

F. O’Kelly & Son Ltd. T/A Timbertrove | Killakee, Rathfarnham, Dublin 16
01 493 1034 | [email protected] | www.timbertrove.com
NEXT ASSEMBLE THE SEAT SECTIONS
5. First, assemble leg sections.
6. Using the end rails, slot into top and bottom of the mortice hole in the
pre-assembled leg section. Fix using 80mm screws
through pre-drilled holes in the leg section repeat for
all sides.
7. Now you have assembled the Seat leg sections, place
the seat top upside down on a level surface making
sure not to scratch the table top. Screw down
assembled leg section using 90mm screws provided,
making sure there is an even space around table top. (Approximately
115mm from leg to end of table top.) Now fix 220mm seat brace
through pre-drilled holes using 60mm screws provided (as shown in
the picture).
IMPORTANT CUSTOMER INFORMATION
To minimise twisting and warping all garden furniture products should only be used on firm level ground.
Softwood is a natural material which can twist and split during periods of wet/dry, hot/cold weather. If
cracks do appear it is a natural occurrence and not a fault with the product or material. The best way to
treat this is to use a cloth and rub a little PVA wood glue into the crack and once dry sand the area lightly.
This will not affect the treatment of the product.