TIRECHECK INTIRE User manual

INTIRE Sensor Installation Manual –Michelin MiniSRT
Patch
For installation of Michelin Mini SRT patch please refer to the latest installation manual provided by
Michelin. The following instructions concern the mounting of sensors into a glued patch.
The following parts are required (except the sensor itself):
Michelin Mini SRT Patch
(already glued onto tire bead toe)
Sensor Clip
Velcro 25 x 120 mm
Installation of the sensor into a patch
1. Before installing the sensor into the patch check the following details:
•Ensure the sensor clip & Velcro are not damaged or broken
•Ensure the Velcro is of size 25 x 120 mm with cut angles 3 x 3 mm
•Ensure the Mini SRT Michelin patch is glued close to the bead toe on the bead protecting
rubber (PT for Protector), not on the butyl inner liner
•Ensure the inside of the tire is clean and dry
2. Slide sensor into the adapter clip (Photo K & L).

INTIRE Sensor Installation Manual –Michelin MiniSRT Patch
2
Document Version 1.3
Photo K
Photo L
3. Slide the Velcro into the patch so that the Velcro is centered in the patch (photo M).
4. Put a sensor and clip onto patch (photo N).
5. Secure the sensor and clip with Velcro.
6. Tighten the Velcro as much as possible so that the sensor does not move after attachment (photo
O).
Photo M
Photo N
Photo O