Titan TS 131A User manual

FOR AUTOMATIC TRANSMISSION ONLYFOR AUTOMATIC TRANSMISSION ONLY
www.titan-innovations.cawww.titan-innovations.ca
Revision 1.01
ADVANCED REMOTE STARTERADVANCED REMOTE STARTER
OWNER'S GUIDEOWNER'S GUIDE

The owner/user MUST INSTALL a CARBON MONOXIDE
DETECTOR in the living area near to where the vehicle is being
stored or parked. It is the sole responsibility of the owner/user
to keep the remote transmitters away from the reach of
children and handle with care so that the system does not
unintentionally start. When the vehicle is parked in an enclosed
/partially enclosed area (ex: garage, car port...), being serviced
(ex: oil change) or if the vehicle is loaned to an operator not
familiar with a remote starter, the system MUST BE placed in
Service (Valet) Mode.
NEVER OPERATE THE SYSTEM IN AN ENCLOSED/ PARTIALLY
ENCLOSED AREA!
MANUAL TRANSMISSION STARTERS the installation of a
remote starter MUST only be done with a specified manual
transmission starter. It is the sole responsibility of the vehicles
owner to insure that the vehicle is left with the transmission in
neutral position when the remote starter is in use. The manual
transmission starter is designed to be an added measure of
safety ONLY! The manufacturer does not guarantee or insure
against any damages or loss of life that could result in the
event of a remote starter starting while the vehicle is in gear.
Manual transmission models are designed only to act as a
deterrent against the vehicle starting in gear, this is the
vehicle’s owner’s and operator’s responsibility.

No Operation
Lock Unlock
Start Car Finder
Button Operations
* This feature is not available for all vehicles.
** Optional feature, requires additional parts & installation.
*** Vehicle must be equipped with factory window roll-up feature.
ACTION FUNCTION
Press LOCK button once Locks doors* and activates Starter Disable**
Press LOCK once then press and hold Window Roll-up***
Press UNLOCK button once Unlocks doors* and deactivates Starter Disable**
Press and hold LOCK for 3 sec Remote panic*
Press and hold UNLOCK for 3 sec Trunk release*
Press LOCK & UNLOCK buttons simultaneously Silent Lock or Unlock
Press START button once Remote engine starter on
Press and hold START button for 3 seconds Remote engine starter off
Press and hold the button for 3 sec Car finder*
Press button once then button for 3 sec Timer Start mode on/off

LOCK
A. Press LOCK button momentarily.
B. Parking lights will flash 1 time, horn will honk 1 time*, doors will lock.
C. The LED on the antenna will begin to flash slowly.
D. If the optional starter-disable circuit has been installed, it will activate as well.
UNLOCK
A. Press UNLOCK button momentarily.
B. Parking lights will flash 2 times, horn will honk 2 times*, doors will unlock.
C. The LED on the antenna will stop flashing. (If passive starter-disable is
programmed, the LED will flash quickly for 60 seconds then rearm automatically.)
D. If the optional starter-disable is installed, it will be deactivated to allow the
vehicle to be started by key.
SILENT LOCK/UNLOCK
A. Press both LOCK and UNLOCK buttons simultaneously.
B. Parking lights will flash once or twice to indicate doors locking or unlocking.
C. Any programmed horn confirmations are temporarily bypassed.
REMOTE START
A. With the engine off, press the START button.
B. The parking lights will flash and the horn will chirp once*.
C. The vehicle’s ignition system will come on and within 3 seconds, the vehicle will
start. (If vehicle does not start, see the diagnostics section for possible solutions.)
D. The parking lights will flash 5 times to confirm a successful start.
E. The vehicle will run for the programmed runtime (15 minute default). To change
your remote starter runtime, contact your dealer.
F. The vehicle can be remotely shutdown by pressing and holding the START button
for 3 seconds.

TRUNK RELEASE --OPTIONAL--
The vehicle must be equipped with a power trunk release switch or a power sliding door to
use this option.
A. Press and hold the UNLOCK button.
B. The doors will unlock and after 3 seconds, the trunk release will activate.
C. The trunk release can also be programmed to work independently on the CAR
FINDER button. If programmed, press and hold the CAR FINDER button for 3
seconds to activate trunk release.
2nd CAR OPERATION
The system can be setup to operate a 2nd vehicle. This feature must be setup at the time of
installation. See your dealer for details.
A. Press the CAR FINDER button in conjunction with any other button to perform
that function on the 2nd vehicle.
PANIC MODE
To use Panic mode, the vehicle’s horn must be connected to your remote starter.
A. Press the LOCK button for 3 seconds.
B. The horn will sound and the parking lights will flash for 60 seconds.
C. Pressing the LOCK or UNLOCK buttons will cancel Panic mode.
CAR FINDER
To use Car Finder mode, the vehicle’s horn must be connected to your remote starter.
A. Press and hold the CAR FINDER button for 3 seconds.
B. The parking lights will flash and the horn will chirp 5 times.
NOTE: Car Finder option is not
available when the trunk release option has been
programmed to work on this button

IDLE MODE (CONTINUOUS RUN)
This option allows you to remove your key and leave the engine running up to the
programmed runtime
A. With the engine running, press the START button.
B. The Horn will chirp twice* and the remote starter will come on.
C. Remove the ignition key and the vehicle will stay running for the length of the
programmed runtime (15 min. default)
D. The vehicle can be shutdown anytime by holding down the START button for 3
seconds or by depressing the brake pedal.
TURBO MODE
This option allows for a cool down on turbo equipped vehicles.
A. With the engine running, press the CAR FINDER button. (Brake pedal must
not be depressed)
B. The parking lights will flash and the horn will chirp 2 times*.
C. Remove the ignition key and the engine will continue to run for approximately 2
minutes.
VALET MODE
This mode disables remote starting and bypasses the starter-disable circuit (if installed).
A. Turn the vehicle ignition key to the on position (you do not need to start the
vehicle).
B. Press and hold the button on the windshield antenna.
C. After about 5 seconds, the parking lights will flash once and you will hear 5 chips
from the vehicle’s horn*.
D. Turn the ignition key to the OFF position. The LED on the antenna will come on
solid.
E. The system should now be in VALET mode.
F. To cancel VALET mode, repeat steps A and B. After 5 seconds, you will see 2
parking light flashes and the horn will chirp 2 times*.
G. The system should now be out of VALET mode.

TIMER START MODE
This option allows you to start your vehicle automatically at preset intervals over a 24-hour
time period.
A. Press and release the CAR FINDER button, then press and hold the START button
for about 3 seconds until the parking lights turn on.
B. With the parking lights on solid, select your start interval using one of the 4
buttons on the remote. (See table below)
C. Once you have selected your start interval, the parking light will shut off and
then flash the setting according to the selection you have made. Example: 2 flashes
= 2 hours
D. The vehicle will start every (your selection) hours for a period of 24 hours.
E. To cancel timer start mode, repeat step 1. The parking lights will flash and the
horn will chirp 2 times*
NOTE: Starting the vehicle by key or by remote will automatically cancel timer
start mode.
Button Flashes Start interval
LOCK 1 Flash Vehicle with start every hour
UNLOCK 2 Flashes Vehicle will start every 2 hours
START 3 Flashes Vehicle will start every 3 hours
CAR FINDER 4 Flashes Vehicle will start every 4 hours

TRANSMITTER LEARNING
STEP 1 - Within 3 seconds turn the ignition key to the “ON”
position three times leaving “ON” the third time.
NOTE:
STEP 3a (Default) - While holding the Program Button, press and
release the button on each of the remote
transmitters to be programmed. If using two
transmitters, code in each transmitter twice.
STEP 3b (PadLoc/ - While holding the Program Button, press and
2nd Car)* release the button on each of the remote
transmitters to be programmed.
If the parking lights do not turn “ON”, release the Program Button and
turn the ignition to the “OFF” position, wait 5sec and repeat steps 1 & 2.
STEP 2 - Press and hold the Program Button. The park
lights will turn “ON” and the horn (optional) will
honk once. Continue to hold the Program
Button, the park lights will turn “OFF” and the
horn (optional) will honk 5 times quickly.
PadLoc is a safety feature that “LOCKS” the remote transmitter. To
“UNLOCK” the remote transmitter the button must be
pressed simultaneously with the function chosen.
or
2nd Car function allows the operation of two remote starter systems
(in two separate vehicles) with one remote transmitter.
Example: Press and release and simultaneously to remote start.
NOTE: Some features not available with PadLoc or 2nd car mode.
Important! The remote starter will hold 4 transmitter codes. It is
recommended that when programming in transmitters, you fill up all
four transmitter codes, even if only using one or two transmitters.
This will clear all other transmitter coding from the unit and prevent
stray coding or possible interference from other remote transmitters.

5 secs
SERVICE (VALET) MODE

Battery Replacement
The transmitter battery should be changed at least once every year to maintain
proper operating range. Replace with the appropriate batteries.
Flashes Problem Solution
3 slow flashes System is in valet mode Cancel Valet Mode
4 slow flashes Door Open Manual trans. models only
5 slow flashes Ignition ON Turn off Ignition key and try again
5 flashes Brakeswitch Contact your product dealer
6 flashes Hoodswitch Contact your product dealer
7 flashes Tach lock-out Start vehicle with key, after 5 sec. try again
Diagnostics
If the remote starter does not activate when the button is pressed, the
park lights will flash a diagnostic code to indicate what shutdown input has
been triggered.

The manufacturer warrants to the original purchaser of the remote starter and/or alarm, that the product shall be
free from defects in material and workmanship. However, should this product be proven to be defective, within
a three year period from the original date of purchase, the manufacturer will, without charge to the purchaser
(excluding any charges incurred to have the product delivered to the manufacturer), repair or replace any part of
the remote starter and/or alarm which the manufacturer agrees to be defective. After the initial three year
period the manufacturer shall repair or replace defective products with a nominal processing fee of $35.00
USD. All warranties apply to the original purchaser and the vehicle in which the unit was originally installed
ONLY. Repairs or replacement of defective modules shall remain at the discretion of the manufacturer. All
other parts, components, accessories, and/or optional equipment pertaining to the remote starter and/or alarm
are not included in the manufacturer's warranty. This warranty is non-transferable. Request for warranty
service from any FactoryAuthorized Dealer must be accompanied with the original purchase receipt. Failure to
comply with any of these conditions may result in warranty being voided. This warranty does not cover the
following: removal and reinstall labor charges, shipping charges, abuse, misuse, or accidental damages to the
remote starter and/or alarm, automobile, and/or parts thereof. This warranty is void upon modification, repairs,
or alterations to any part of the product. The manufacturer does not guarantee or insure against theft of the
vehicle or its contents. Alarm models are designed only to act as a deterrent against possible theft. This alarm
may qualify for auto insurance discounts. Contact your insurance agent for further information. The
manufacturer shall not be held liable for any consequential damages due to breach of this or any other warranty,
expressed or implied. This warranty gives you specific legal rights. Your specific legal rights may vary for each
region.
CERTAIN DAMAGES EXCLUDED – The manufacturer expressly disclaims any liability or responsibility for
incidental damages caused by the product, including economic loss, loss of use of the product, car rentals, or
any other costs relating to the care and custody of the product. The manufacturer disclaims liability or
responsibility for any consequential damages caused by the product or resulting from its use, including the cost
of repairing or replacing other property damaged by the product or caused by its use, whether or not the product
is working properly. The product is intended to deter unauthorized use of the vehicles in which it is installed.
The manufacturer does not warrant that the product is fool-safe against theft and/or vandalism and/or human
error or misuse. The manufacturer accepts no liability or responsibility for any damage of any kind whatsoever
caused to any vehicle in which the product is installed or any resulting damage from its use. The manufacturer
accepts no responsibility or liability for any damage resulting to or theft of the vehicle or its contents caused or
alleged to be caused, directly or indirectly, by failure of the product.
MANUAL TRANSMISSION STARTERS – The installation of a remote starter in a manual
transmission vehicle MUST only be done with a specified manual transmission starter. The
manual transmission starter is designed to be an added measure of safety ONLY! The
manufacturer does not guarantee or insure against any damages or loss of life that could result
in the event of a remote starter starting while the vehicle is in gear. Manual transmission models
are designed only to act as a deterrent against the vehicle starting in gear. It is the sole
This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
(3) CAUTION: Changes or modifications not expressly approved by the part responsible for

FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for
compliance void the user’s authority to operate this devise.
www.titan-innovations.cawww.titan-innovations.ca