Toa HY-ST04 User manual

INSTALLATION MANUAL
SPEAKER STAND ADAPTER
HY-ST04
Thank you for purchasing TOA’s Speaker Stand Adapter.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
• Before installation or use, be sure to carefully read
all the instructions in this section for correct and
safe operation.
• Be sure to follow all the precautionary instructions
in this section, which contain important warnings
and/or cautions regarding safety.
• After reading, keep this manual handy for future
reference.
Indicates a potentially hazardous situation which,
if mishandled, could result in death or serious
personal injury.
WARNING
• Sinc e the unit is designed for indoor use, do not install
it outdoors. If installed outdoors, the aging of parts
causes the unit to fall off, resulting in personal injury.
• Do not use other methods than specied to mount
the bracket. Extreme force is applied to the unit and
the unit could fall off, possibly resulting in personal
injuries.
• Tighten each nut and bolt securely. Ensure that
the bracket has no loose joints after installation
to prevent accidents that could result in personal
injury.
Indicates a potentially hazardous situation which,
if mishandled, could result in moderate or minor
personal injury, and/or property damage.
CAUTION
• Avoid touching the unit’s sharp metal edge to
prevent injury.
• Do not stand or sit on, nor hang down from the unit
as this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
2. GENERAL DESCRIPTION
The TOA HY-ST04 is the dedicated speaker stand
adapter for the SR-F04 Speaker system. It allows the
SR-F04 to be mounted in a vertical orientation.
3. DIMENSIONAL DIAGRAM
70 (2.76") 130 (5.12")
101 (3.98")
82.6 (3.25")
[Top]
[Side] [Front]
Unit: mm
• Have the unit checked periodically by the shop from
where it was purchased. Failure to do so may result
in corrosion or damage to the unit or its mounting
bracket that could cause the unit to fall, possibly
causing personal injury.
4. SPECIFICATIONS
Finish Steel plate, black, semi-glossy, paint
Dimensions 130 (w) x 82.6 (h) x 70 (d) mm
(5.12" x 3.25" x 2.76")
Weight 300 g (0.66 lb)
Applicable
Stand
Optional ST-34B or the generic speaker
stand with a ø35 mm pipe
Note: The design and specications are subject to change
without notice for improvement.
• Accessories
Speaker mounting knob bolt (M8) . ............ 2

URL: https://www.toa.jp/
133-01-00262-00
Traceability Information for Europe
Manufacturer:
TOA Corporation
7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo, Japan
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg, Germany
5. INSTALLING TO THE OPTIONAL SPEAKER STAND
For the setup and the height adjustment of the speaker stand, read the instruction manual enclosed with the speaker stand.
Step 1. Remove 2 screws on the speaker's bottom surface.
Step 2. Attach the adapter to the speaker with the
supplied speaker mounting knob bolts.
Note
The screws removed in Step 1 cannot be used.
Step 3. Mount the speaker attached with the adapter
onto the speaker stand.
Step 4. Determine the speaker direction, then tighten
the bracket xing knob bolt.
1
Speaker mounting
knob bolt
(M8, accessories,
2 places) Bracket fixing
knob bolt
Speaker
2
3
ST-34B Speaker stand
(option) or
the generic speaker stand
with a ø35 mm pipe
4