8Connect the throttle wires to the Honda
Engine wires. Left to Left. Right to Right.
10 Remove the air filter to access the
engine’s throttle control terminal.
12 Pull the housing back and slide the end of
the cable into the engine’s throttle terminal.*
TBS500: Skid Sprayer Assembly Pt.2 www.tomahawk-power.com
7Attach the throttle control using the last 2
screws and nuts.
9Place the throttle cable end into the gap and
fit the cable along the top of the throttle.
11 Fit the top of the cable housing into the
slot and tighten the locknuts.
* Move the throttle control back and forth to make sure the cable is engaged.
