
The Remedy 2.0 ER
Instructions for Use
Please read these instructions completely and carefully
before applying this product. Correct application is important for proper function of this product.
Indications: Immobilization and support of the shoulder/post-operative recovery
Application Instructions:
Sling & Pillow
A. Wrap and secure waist belt with sling around the patient’s waist.
Open wrist and forearm strap clips and elbow closure on the sling
(Image A). Trim excess strap to desired length (Image A-1).
B. Place forearm into sling so that the hand is supported by the sling.
Fasten wrist strap clip and then the forearm strap clip. The wrist
and forearm should be held snugly against the pillow. Hook/loop
straps may be adjusted as appropriate. (Image B-1) Secure the
posterior elbow strap to the waist strap to hold the elbow against
the pillow.
C. Secure shoulder strap from the front of the abduction pillow over
the aected shoulder and attach strap to the waist belt under the
aected shoulder (Image C). Adjust strap as necessary for proper
t.
D. Excess strap material may be trimmed by removing the y-tab, trim
the strap length then reapply the y-tab (No image).
E. Properly applied Remedy 2.0 ER (Image E).
Conversion to a Shoulder Immobilizer
F. Detach sling and sling straps from pillow. Detach pillow from sling
and remove strap clips from sling straps (Image G).
G. Attach sling to waist just below the plastic D-rings (Same Image).
H. Wrap and secure waist belt with sling around the patient. Place
forearm into sling so that the hand is supported by the sling. Feed
wrist strap through D-ring and secure. Feed wrist strap through
D-ring and secure. Feed forearm strap through D ring and secure
(Same Image).
I. Secure the posterior elbow strap to the waist strap to hold the
elbow against the body (Same Image).
J. Properly applied Remedy 2.0 ER without pillow
(Image J).
FG
HI
J
E
AA-1
BB-1
C D
Back
Back