TOP VEHICLE TECH GR4VW2 User manual

www.topvehicletech.com
The informaon provided in this document is subject to change without noce due to changes and/or
improvements to the product/s.
V1.0522
VOLKSWAGEN
2003-2016
INSTALLATION MANUAL
This dash image is a visual representaon for display purposes only.
GR4VW2

2
www.topvehicletech.com
ABOUT THIS PRODUCT
The GR4VW2 installaon kit allows for the retenon of the vehicle’s steering wheel controls and maintains the
original aesthec of the interior when installing a new car stereo. The GR4VW2 gives you everything you need
for a complete install in one box. The components of this kit are compable for the following vehicles with
RCD200/RCD300/RCD310/RCD500/RCD510 factory stereos:
Amarok (2H) 2009 - 2016 EOS (1F) 2006 - 2015 Golf (MK5/6) 2003 - 2013 Jea 2005 - 2015
Passat (B6/B7) 2005 - 2015 Polo (9N/9N3/6R) 2009 - 2014 Scirocco 2008 - 2015 Touran 2006 - 2015
Tiguan (5N) 2007 - 2015 Transporter 2009 - 2015
The wiring harness and interface will retain the steering wheel controls and factory phone buons (if vehicle is
equipped). Supplied with a Quadlock connector.
CUSTOMER SUPPORT
Installaons should be carried out by, or under the guidance of an experienced installer. If you do encounter any
problems during the installaon of this product, then please contact our dedicated customer service team at:
Phone: [phone] E-Mail: [e-mail]
CONTENTS
• 1x Fascia plate (with accessories)
• 1x Instrucon manual
• 1x Steering wheel control harness and interface
• 1x Antenna adapter
• 1x DAB antenna adapter
• 1x Stereo patch lead

3
www.topvehicletech.com
FITTING GUIDE
FASCIA PLATE SET-UP
1. Take the new fascia and place it into the dash where the OEM radio used to sit, once placed correctly,
screw into place using the factory screws.
3. With the cage secured into place, and once the “Stereo Installaon” process is complete, simply slide
the stereo into the fascia.
2. Take the pocket and install it into the preferred aperture (most commonly this is installed within the
boom port).
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet MUST be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heang elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be dropped down to route the antennas wiring. To do this, rst remove the
glovebox side panel. Then remove 3x screws located within the lip of the glovebox, as well as 3x located
underneath. Once free, pull out and drop down into the footwell.
1a. Use a panel removal tool to release the air cone unit and remove 2x screws located here (this step is
only required for Volkswagen Golf vehicles).
1b. Use a panel removal tool to remove the trim surrounding the main radio. This will reveal 4x screws
which will need to be removed.
2. Once free, pull the head unit out of the dashboard and disconnect all of the wiring in the process.

4
www.topvehicletech.com
FITTING GUIDE
STEREO INSTALLATION
5. Aach the addional wiring on the harness to the back of the stereo:
Pink - Speed Pulse Green - Park Brake Purple - Reverse
6. When all the above wires (and any addional accessories) have been connected, nally make the
connecon between the stereo and the vehicles pre-exisng connector.
4. Aach the antenna adapter to the vehicles pre-exisng connecon and the back of new stereo.
3. Connect the DAB antenna’s SMB connector to the back of the new stereo.
1. Take the steering wheel control interface in hand and connect both the 12-way stereo patch lead and
the 14-way steering wheel harness connectors to the corresponding sides.
2. Connect the bullet connector from the stereo patch lead to the ‘steering wheel remote input’ on the
back of the new stereo.

5
www.topvehicletech.com
Please note: conguraon layout may dier dependent on vehicle model.
STEERING WHEEL CONTROL FUNCTIONALITY
1
2
3
45
6
OK
7
1
2
34
5
6
Version 1
Version 2
1. Volume +
2. Volume -
3. Track -
4. Track +
5. Mute
6. Pick Up (Short Press) Hang Up (Long Press)
1. Volume +
2. Volume -
3. Track -
4. Track +
5. Mute
6. Pick Up
Original Buon New Funcon
1
2
3
45
6
OK
7
1
2
34
5
6
Version 1
Version 2
1. Volume +
2. Volume -
3. Mute
4. Pick Up (Short Press) Hang Up (Long Press)
5. Source
6. Track +
7. Track -
1. Volume +
2. Volume -
3. Star
4. Pick Up
5. OK
6. Track +
7. Track -
Original Buon New Funcon

6
www.topvehicletech.com
ISO Connector
Connect to new stereo
Quadlock Connector
Connect to connector from vehicle
Main Wiring Loom Connector [14 Pin]
Connect to Interface Box
Interface Box
Flying Wires
Pink - Speed Pulse
Green - Park Brake
Purple - Reverse Gear
Stereo Patch Lead Connector [12 Pin]
Connect to Interface Box
Note: Must be connected first, before
power connection is made to the
interface
Stereo Patch Lead Bullet Connector
Connect to ‘Steering Wheel Remote
Input’ on back of the stereo.
WIRING DIAGRAM

7
www.topvehicletech.com
NOTES

8
www.topvehicletech.com
If at any point you experience any problems and need any assistance before, during or aer the
installaon process, please contact us via :
Phone: [phone]
E-Mail: [e-mail]
Mon - Fri 9am - 5.30pm GMT
TECHNICAL ASSISTANCE
If you would like to download a digital copy of this manual, or any other product, then please
visit the www.topvehicletech.com website.
This manual is considered correct at the me of prinng but is subject to change. For the latest
manuals & updates, refer to our website.
Copyright 2022 by TopVehicleTech.
All rights reserved. No part of this publicaon may be reproduced, distributed or transmied
in any form or by any means, including photocopying, recording, copying or other electronic or
mechanical methods, without the prior wrien permission of the author.