TOPMAQ ZD04152Q-J User manual

IMPORTANT:
PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY. NOTE THE SAFETY
INSTRUCTIONS & WARNINGS. USE THE PRODUCT CORRCTLY AND WITH CARE FOR THE
PRRPOSE FOR WHICH IT IS INTENDED.
Parameter
CAPACITY : 1500 LBS
MIN HEIGHT : 180 MM
MAX HEIGHT : 830 MM
Features
1. Air or Hydraulic Powered Mechanism
2. Removable plate for increased access, such as rear wheel removal
3. Adjustable foot for increased safety and stability
4. Safety set increases safety against accidental descent of table
Operation
1. Ensure that the table is at the minimum height, and that the ramp is in place.
2. Lock off the release valve, steadily pump the foot pedal until the table reaches
a required height, or using the air pump to lifting the motorcycle lift. Connect
the hose to the air feeder directly before operate the air pump, then press
valve to rise the table, and loosen the valve to stop.
3. Lock the safety set at the required height. Then repair the motorcycle.
4. After repairing, remove the safety set.
5. Steadily pump the foot pedal, Let the table lower
6.Remove the motorcycle from its stand and wheel it off the back of the table via
the ramp.
Maintenance
1. The mechanical parts of the lift, such as the foot pedal and release shafts
should be occasionally lubricated with heavy oil or grease.
2. Protect the lift cylinder from dirt or dust. If it becomes dirty, wipe it off with a
clean cloth.
3.Maintain and store the Lift in a reasonably protected environment. Do not
expose to rain or excess moisture. Protect from salt water or other corrosive
materials.
Warning
1. Always check the lift before use,
2. Do not operate under the table, keeping hands and body away from the table
when it’s operating. The air hose should be pulled from bottom, not on the table.
3. When lowing the table, take care to control the speed of descent.
4. When the table is at its highest elevated position, do not attempt to pump the
table higher as this can damage the mechanism.
REPALR PARTS：

PARTS LIST
No. Description Qty No. Description Qty
1 Insurance Switch 1 20 Insurance Support Plate 1
2 Bolt M6×30 1 21 Washer 22
3 Bolt M8×15 2 22
Bolt M10×20 4
4 Washer 2 23 Pulley 4
5 Insurance Switch Handle 1 24 Side Plate 1
6 Steel Wire 1 25
Bolt M10×20 2
7 Support Arm 1 26 Side Oblique Plate 2
8 Cylinder 1 27
Bolt M16×90 2
9 Bolt M16×80 1 28 Nut M16 2
10 Support feet handwheel 2 29 Side Table Plate 2
11 Support feet 2 30 Removable Plate 1
12 Washer 3 31 Table Plate 1
13 Nut 3 32 Clamp Baffle 1
14 Pin Shaft 4 33 Bolt M10×70 2
15 Pump 2 34 Butterfly Nut 2
16 Hatch Pin 5 35 Shake Handle 1
17 Pin Shaft 1 36 Clamp 1
18 Washer 8 37 Bolt M10×30 2
19 Bottom Frame 1
1500LB ATV/ MOTORCYCLE LIFT
(Air/Hydraulic)
INSTRUCTION MANUAL
RETAIN THIS MANUAL FOR FUTURE REFERENCE
PLEASE READ THIS MANUALCAREFULLY BEFORE USE