Tork Winch TW 2000 User manual
MOUNTING WINCH ON A FLAT SURFACE
MOUNTING WINCH TO A PIPE (SEE FIG. 1)
PLEASE NOTE:
Do not over tighten U-bolts; over tightening can cause
deection and weakening of the frame – creating an unsafe
situation and voiding warranty.
WINCH WIRING (SEE WIRING DIAGRAM PG. 2)
Do not use long extension cords to power the winch.
connecting the winch during installation period. Running
the winch under degraded voltage conditions will result
in overheating, low power and damage to the capacitors.
PLEASE NOTE:
The winch limit switches are pre-wired at the factory. Do not
test run the winch with the limit switches bypassed as this may
cause over–travel of the limit mechanism and result in damage
to the winch.
P: 1-866-829-4411
F: 1-519-539-9191
USA: Tork Winch USA LLC
CANADA: Tork Winch
INSTALLATION INSTRUCTIONS
GYMNASIUM
CAUTION
1. As with any lifting device, the installation shall
be made only by persons suitably experienced
and qualied for work on hoisting equipment,
in accordance with local requirements.
2. The electrical supply and connection to the winch
shall be made in accordance with local electrical
code and by qualied personnel.
3. The instructions address the areas of proper
mounting, rope installation, wiring and limit switch
adjustment, but they are not intended to cover
every aspect of installation of your hoisting
system, not to replace the need for normal good
care, workmanship and proper practices on part
of the installer.
P: 1-866-829-4411
F: 1-519-539-9191
USA: Tork Winch USA LLC
CANADA: Tork Winch
GYMNASIUM
WIRE ROPE INSTALLATION (SEE FIG. 2)
(Use extreme caution and keep hands and clothing away
from moving parts).
6. A)
B)
PLEASE NOTE:
Put only three “dead wraps” on the drum at the start of the lift.
Excessive dead wraps use space on the grooved drum-forcing
the rope onto a second layer when it is not needed.
LIMIT SWITCH ADJUSTMENT
Do not over tighten thumb nuts as this may crack the
limit switches.
PLEASE NOTE:
One upper and one lower travel limit switch is provided. Proper
adjustment is simple and quick with the following procedure.
Always shut power off from the winch when working inside the
electrical compartment. The cover has been designed for quick
removal to simplify limit switch adjustment.
INSTALLATION INSTRUCTIONS
EMERGENCY LOWERING OF BACKSTOP IN CASE
OF POWER FAILURE
PLEASE NOTE:
P: 1-866-829-4411
F: 1-519-539-9191
USA: Tork Winch USA LLC
CANADA: Tork Winch
INSTALLATION INSTRUCTIONS
GYMNASIUM
1-866-829-4411
TW 2000 DETAILS AND DIMENSIONS
∙
∙
∙
Table of contents
