Toto EGO II TX445SECMV3 User manual

8
S06435MR
"EGO II" CROSS HANDLE FLOOR STANDING BATH
& SHOWER SET
SPECIFICATIONS TROUBLESHOOTING
CHECK
POINT
Unsatisfactory spray 1 Clean
Flow rate unsatisfactory 2 Remove and clean
Water leaks around the handle 3 Tighten
PROBLEM
SOLUTION
3. CERAMIC
HEAD WORK
2. AERATOR
Handle Set *
258
120
630.5 194.5
150
45
55
Ø72.5
Ø80
G½
18
8250
-8
54+8
0
Ø8
40
7
Flexible Hose
w/ Packing
Shower
Packing
Body
5
43
INSTALLATION
1
Make sure the floor is flat
* Remove the coverafter the
mortar has dry
2
6
* Cover
Mortar
Maximum
Mortar
Minimum
Mortar
Nut
Flexible
Hose
Cover
Base
Drill
Hot Water
Supply *
Sleeve
Anchor
6 - Hole 8
Base
Cold W ater
Supply *
Screw
Flow Regulator Inside
(Don t remove)
R5
* Pipe supplied by owner
Rain Spray
Button
Massage
Spray Button
TX445SECMV3
1. NOZZLES
Ring
Hanger
OPERATING CONDITIONS
MAINTENANCE
ATTENTION
1. Watersupply pressure : 0.05 ~ 0.75 MPa.
2. Ensure that watersupply is clean ( NoSand, Dirt, Etc.).
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and
are not recommended for cleaning
Handle reinstallation
1.
2.
* Redhandlefor left side andblue handle for right side. Tighten by hand
Nut *
* Turn the nut
4.
Don t use abrasive cleaners or solvents on faucets and fittings.
FlowRegulator should not be remove because it could damage the
system
As the product model is constantly updated, the actual product may
not look the same asit shownin the diagram, but the basic
installation principles are the same.
The hot watersupply side of the faucets is ina condition of high
temperature.Do not allow skin to contact with the hardwaresurface
directly. Otherwise, scalding mayoccur.
2.
1.
3.

8
S06435MR
"EGO II" CROSS HANDLE FLOOR STANDING BATH
& SHOWER SET
SPESIFIKASI
3. CERAMIC
HEAD WORK
2. AERATOR
Handle Set *
258
120
630.5 194.5
150
45
55
Ø72.5
Ø80
G½
18
8250
-8
54+8
0
Ø8
40
7
Flexible Hose
w/ Packing
Shower
Packing
Body
5
43
PEMASANGAN
12
6
* Cover
Mortar
Maximum
Mortar
Minimum
Mortar
Nut
Flexible
Hose
Cover
Base
Drill
Hot Water
Supply *
Sleeve
Anchor
6 - Hole 8
Base
Cold W ater
Supply *
Screw
Flow Regulator Di dalam
(Jangan dilepas)
R5
Rain Spray
Button
Massage
Spray Button
TX445SECMV3
1. NOZZLES
Ring
Hanger
Nut *
* Putar nut
KONDISI OPERASIONAL
PEMELIHARAAN
* Handle merah untuk posisi kiri andhandle biru untuk posisi kanan.
Kencangkan dengan tangan
PENYELESAIAN MASALAH
PERHATIAN
Pastikan lantainya rata
* Lepas cover setelah
mortar mengering
* Pipa disediakan oleh pemilik
Pancaran tidak memuaskan 1 Bersihkan
Laju aliran tidak memuaskan 2 Lepas dan bersihkan
Air bocor disekitar handle 3 Kencangkan
MASALAH
SOLUSI
POIN
PERIKSA
1. Tekanan sumber air: 0.05 ~ 0.75 MPa.
2. Pastikan kondisi sumber air adalah bersih (tidakada pasir,
kotoran dan lain lain)
Seluruh lapisan: Bersihkan lapisan akhir dengan sabun lembut
dan air hangat. Lap seluruh permukaan hingga benar-benar
kering dengan kain lembut yang bersih. Kebanyakanbahan
pembersih mungkin mengandung bahan kimia, seperti amonia,
klorin, pembersih toilet, dll. yang dapat mempengaruhi hasil akhir
dan tidak disarankanuntuk dibersihkan
Handle reinstallation
1.
2.
4.
Jangan gunakan pembersih atau pelarut abrasif pada faucet dan
fitting.
FlowRegulator tidak boleh dilepas karena dapat merusak sistem
Karena model produk terus mengalami pembaharuan, aktual
produk mungkin tidak samadengan gambar, tapi prinsip dasar
pemasangan adalah sama.
Sisi pasokanair panaspada kran faucet berada dalam kondisi suhu
tinggi. Jangan biarkan kulit menyentuh permukaan benda secara
langsung. Kalautidak, bisaterjadi kepanasan.
2.
1.
3.