TP-Link NC450 User manual

Connect the NC450 and your smartphone
to the same router, then connect the power
cord and internet cord to the NC450. If the
cord is long enough, please use Method A
below. If not, use a Passive PoE Injector to
connect, as shown in Method B.
Place the camera where you want it. You can
place it on a at surface, or mount it as shown
on the back of this guide.
Download the tpCamera app. Once installed,
open it and follow the instructions to add
the camera to your TP-Link ID.
View live video using the tpCamera
app or TP-Link Cloud website.
Via tpCamera: On the "My Cam" screen,
tap your camera to view video. Change the
camera angle using the pan and tilt
controls.
Via TP-Link Cloud website: Log in at
https://www.tplinkcloud.com and select
your camera to view live video.
Quick Installation Guide
Flashing red: System starting
Solid red: Network not connected
Solid green: Network connected
System LED
OR
Short Press to trigger WPS; Press and
hold for 5 seconds to trigger Reset.
More functions with tpCamera
Get notications when motion is
detected, and view alerts history.
Stay in touch with 2-way audio.
View all of your cameras on one screen by
downloading the TP-Link Camera Control
utility. See the Camera Control User Guide
for more details. Or visit us online at
www.tp-link.com for Camera Control utility,
Firmware, and other support.
Connect Register Relocate View and Enjoy
WPS (Wi-Fi Protected Setup): If your Wi-Fi
router supports WPS, you can connect the
camera to your Wi-Fi network using WPS.
For details, see the camera’s User Guide.
The WPS/Reset Button Mounting Kit
Wall Mounting
Place the paper drill guide where you want
the camera. Check the alignment using
a level. Using a 0.24 inch (6mm) drill bit, drill
holes through the two circles on the guide.
Remove the paper.
Insert the two anchors into the holes and
place the camera mount over the anchor.
Attach the camera and use the screws to
secure it.
Mount Base Secure Camera
1
2
3
1
2
3
Drill Holes
Mount Base Secure Camera
1 2 3
1 2 3 4
1 2 3
Drill Holes
Camera Ceiling mount kit
Base Wall mount kit
Ceiling Mounting
Place the paper drill guide where you want
the camera*. Using a 0.24 inch (6mm) drill
bit, drill holes through the two circles
on the guide. Remove the paper.
* Camera placement can aect viewing angle. For best
results, place the camera near a wall or corner.
Attach the camera mount using the
screws, washers and wingnuts.
Attach the camera and use the screws to
secure it.
Camera
Passive
POE
Injector
Outlet
Wireless Router
Smartphone
LANWAN
Internet
Camera Outlet
A B
WPS/
RESET
For technical support and other information,
please visit http://www.tp-link.com/support.
Support
©2017 TP-Link

tp-link.com
Cover any angle from anywhere
7106507648 REV2.1.0