TPI 1450 Series User manual

Replacement inner ap
TPI air inlet valves
1450-series
2.
2
3 4
1
Exercise cauon when unscrewing the old innerap! The spring unit is located
underneath the le side of the ap. If that side is unscrewed and the ap
pulled up, the spring will jump back. This may injure your ngers! Wear safety
glasses during replacement!
Mounng instrucons
1. Start with the right side of the innerap. Simply slide the ap into the frame. Do
not forget the plasc washer, also shown in picture 3.
Pull up the ap on the le side. Place the plasc washer as shown in picture 3.
Then replace the black bracket and place the transparent plasc strip over the
spring as shown in picture 4.

3.
4.
Turn the spring one complete revoluon clockwise as shown in pictures 5 & 6 and
push the ap down as shown in picture 7.
The spring should point towards the front of the inlet before it is pushed down!
NOTE: Cauon!! Use a good pair of tongs and take care not to injure your ngers!
Turn the spring counter clockwise in case of self-closing execuon.
Mount the last two screws as shown in picture 8.
5
7
6
9
8
Telephone: [phone]
Fax: [phone]
E-mail: inf[email protected]
Internet: www.tpi-polytechniek.com
TPI-Polytechniek BV
De Steenbok 24
5215 ME ‘s-Hertogenbosch
Holland