Tracker T593024H-ELG User manual
.Box Damage Claims
Freight Damage: All safes are carefully packed for shipment. The manufacturer’s liability ceases
when the transportation carrier accepts the shipment in good condition. The carrier’s liability ceases
when you sign for the merchandise. Inspect your shipment before signing the delivery receipt. If
damaged, note the damage on the delivery receipt and file a damage claim with your freight carrier.
Tracker Safe
www.trackersafe.com
(360) 213-0363
LOW BATTERY WARNING
Repeated beeping during an opening indicates that the battery is low and needs immediate
replacement.
Always use one QUALITY 9-volt alkaline battery. LA GARD recommends replacing the
battery annually.
CHANGING THE BATTERY
1. Remove the screw in the black cover located at the bottom of the keypad to expose the
battery compartment.
2. The connector is easily removed by unsnapping it from the two terminals on the top of the
battery. CAUTION! Hold onto battery terminal to avoid pulling wires from housing!
3. Remove the 9 volt alkaline battery and replace with a new quality 9 volt alkaline battery.
4. Once the battery is replaced, make sure there are no cables or wires trapped between the
keypad, black cover or the safe door. Pinched cables or wires can result in a short circuit.
5. Replace the black cover with the screw to hold the battery in place.
Model: T593024H-ELG
24 Gun, Electronic Lock
Extra Fireboard
Serial #:_______________________
READ THIS USER’S MANUAL CAREFULLY BEFORE USING!
DO NOT LOCK THIS USER’S MANUAL INSIDE THE SAFE!
THE SAFE SHOULD BE BOLTED TO THE FLOOR BEFORE USE!
SAFE
USER MANUAL
!!! WARNING !!!
USE CAUTION AS THE UNLOADED SAFE IS FRONT HEAVY WITH
THE DOOR IN THE OPEN POSITION!
THE SAFE SHOULD BE BOLTED TO THE FLOOR BEFORE USE!
NEVER LEAVE THE SAFE UNATTENDED WITH THE DOOR IN
THE OPEN POSITION!
*** IMPORTANT NOTES - READ BEFORE OPENING ***
**Keep your Invoice and this User Manual with the safe’s Serial Number
and Electronic Lock Instructions in a secure place, away from children
and not placed inside the safe.
**NEVER move the safe using its handles. Handles should be used only
to open and close the safe door.
**Practice unlocking and locking the safe with the door in the OPEN
position PRIOR to closing the door and locking the safe for the first time.
**NEVER force the handle to turn. If the Combination has been entered
correctly the handle will turn easily. Trying to force the handle to turn
after dialing an incorrect combination can jam the locking mechanism in
the locked position.
ELECTRONIC COMBINATION LOCK INSTRUCTIONS
OPENING THE SAFE:
The factory pre-set Manager Code is 123456. To open, SLOWLY enter the
factory pre-set Manager Code. All codes must be six (6) digits in length.
**NOTE**
IF COMBINATION IS INPUT INCORRECTLY FOUR TIMES, YOU
WILL BE LOCKED OUT OF THE SYSTEM FOR 5 MINUTES!!!
CHANGING THE MANAGER CODE:
**ALWAYS PERFORM THIS OPERATION WITH DOOR OPEN **
1. Enter “zero” six times.
2. Enter your existing six (6) digit code one time.
3. Enter your NEW six (6) digit code TWO times.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1-3.
5. Test lock operation several times before closing the door.
Valid Code Entry : Double signal after valid six digit code is entered.
Invalid Code Entry: Triple signal and old code is still valid.
USING YOUR NEW SAFE
CLOSING THE SAFE
Caution: Make sure the door-bolts are fully retracted before closing the
safe door. Closing the door with the door-bolts partially extended can
cause damage to your safe’s operating mechanism, making it inoperable.
Close the door until the door stops against the door frame and turn the
safe handle counterclockwise approximately 45 degrees.
