XDeer S10 User manual

(S10)
SAFE

1.Emergency Lock
2.Fingerprint Collector
3.PIN Code
4.Battery Compartment
5.Programming Button
6.LED
：

1
2
3
456

：
· Expansion Screws
· XDeer Gun Safe S10
· Backup Keys
· Owner’s Manual
 
· Security Cabinet
SAFE
· Corner Stickers

：
Insert the key, open the door
1
Insert 4xAAA alkaline batteries
2
34
Remove the battery unit indicated by
6
Please align this hole to insert the battery box

keyhole
6

：
2.Release setting button, input 4-6 digital
new code then press the setting button
again.
3.Code setting is successful if blue LED
ashes 2 times with 2 beeps.
CAUTION: Code setting fails if blue LED ashes 5 times with 5 beeps
1.Press and hold the setting button
until the blue LED ashes one time with
one beep.
5

5
Tips: The initial password is 1234

：
2.Release setting button, nger swipe
across ngerprint scanner for 4 times.
3.Finger setting is successful if blue LED
ashes 2 times with 2 beeps.
CAUTION: Code setting fails if blue LED ashes 5 times with 5 beeps
(The blue LED ashes whenever you enter
ngerprint scanner, and you need record 4
times continuously)
1.Press and hold the setting button
until the blue LED ashes one time with
one beep.
5

5

：
CAUTION: Code setting fails if blue LED ashes 5 times with 5 beeps
2.There is one beep and blue LED ashes
one time and don’t let go.
3.Keep holding the setting button, there
are 2 beeps and blue LED ashes 2
times.
1.Press and hold the setting button
and don’t let go.
5
4.Release setting button.
5.All the ngerprints have been erased.

5

：
！
Do not use rechargeable batteries or any other type of non-
alkaline battery. Do not mix old and new batteries. Do not mix
alkaline and standard batteries.
！
5-times wrong code will activate 5-minute blue LED ashes
(You can stop it by using key to open it and remove the battery)
and the keypad will be locked 5 minutes.
！
Do not lock the key inside safe.


1.Fix the safe in the place which is not easy to move.
2.Drill holes for expansion bolts in the right place.
3.Turn the expansion bolts counter clockwise to separate.
4.Use the expansion bolts to secure the case to the platform.
5.Make sure the case is mounted in place as required and then tighten
all screws.
CAUTION: Use the expansion bolt when there is a concrete platform
surface. Use the clamping screw when there is a wooden platform
surface
：
 