TRAK RACER TR80-SLIDER User manual

1
TR80-SLIDER
Manual

2
STEP 1 Add the seat
slider as shown below.
Start with placing the rails with the flat side upwards and the metal protrusions facing
inwards. The leaver should be pulled upwards to unlock the rails.
Now slightly fasten the front bolt of the rails just enough to keep it in position but
allow the rails to swivel at the back slightly to align the back bolt without any tension.
Now use a screwdriver (or the leaver) on the metal protrusions on the inside to slide
the rails forward to gain access to the back bolt, now fully tighten the back bolt.
If that bolt is tightened slide the rails backwards again to regain access to the front
bolt and fully tighten it. After fully tightening the rails, bring the rails back to the
neutral position and mount the other side in the same way.
After both rails are in neutral position and tightened, it’s time to add the leaver.

3
STEP 2
The leaver needs to be bent outwards a bit further than the actual width of both rails.
Now place one side with the holes in the protrusions with the other side just above
the rails and apply a bit of force inwards to overcome the resilience, now align the
leaver with the other end of the rail’s protrusions.
STEP 3
If the leaver is placed and it unlocks/locks the rails correctly, continue mounting the
seat brackets.
First pull the leaver and slide the rails forward to insert the front bolts and nuts. After
slightly tightening the front bolts on both ends, slide the rails backwards again to
access the backside of the seat rails. Insert the back bolts and slightly tighten those.
Note: before fully tightening the seat brackets its recommended to test fit the seat.

4
That’s it, you are done!
We wish you a lot of fun with your freshly built equipment.
Thank you for choosing Trak Racer