REPAIR AND REASSEMBLE CLAMP
With all parts and pieces
separated, put the clamp
housing on the smaller
diameter pole segment.
1
Attach the gray plastic clip to the smaller pole segment. There are two protruding
lobes that hold the clip in place at the bottom of the pole - orient them up toward
the clamp housing. The piece should be flush with the base of the pole segment.
3
Insert the small friction locking piece
into the clamp housing slot. The
point should be oriented down, and
the flat surface should be facing up.
6Drop the clamp into the slot. Line up the
hinge pin and push it into place until it is
flush and the clamp is fully operational.
7
2Assemble the plastic clamp sleeves on the smaller
pole segment. Slide the larger white sleeve on
below the clamp housing. Then slide the second
clamp sleeve on below the first. Align the cutouts
on each sleeve with the clamp hinge.
Connect the two pole segments.
Slot the white clamp sleeves all
the way into the larger diameter
pole segment.
45Slide the clamp housing all the way down
onto the larger diameter pole segment.
The cutout on the larger pole should be
facing the same direction as the clamp
housing so that they cutouts line up.
