Trelleborg TPMS User manual

Trelleborg Wheel Systems Page 1 of 3
QUICK REFERENCE
TPMS DRIVER DISPLAY INSTALLATION MANUAL
The driver display can be mounted on any surface inside the vehicle using the display holder.
1. Ensure the driver display is installed in the driver line of sight.
2. Ensure the display does not impede the driver line of sight or vision.
3. Ensure the display is not installed upside-down.
4. Do not place the display directly at a ventilation outlet or in places where it can limit driver operation
of the vehicle.
5. Always check with the driver for a suitable position for driver display.
6. Ensure the surface is clean and free from grease before adhering the mounting base.
Example of display’s position in Volvo wheel loader.
7. Pull the protective film away from the adhesive surface on the mounting base.
8. Place the mounting base with the adhesive point on the clean surface and press down. Ensure that
the connecting piece of the mounting base is facing you.
Example of display’s position in Caterpillar dump truck.

Trelleborg Wheel Systems Page 2 of 3
9. Connect the display holder to the mounting base by guiding the display holder into the guide rail of the
mounting base.
10. Guide the grooves of the driver display into the lugs of the display holder (See image A below).
11. Press the driver display on the upper end into the rear anchoring of the display holder until you hear a
"click" (See image B below).
12. Press the two wings on the side of the display holder together to disconnect the display.
13. Guide the grooves of the driver display out of the lugs of the display holder after the upper part of the
display pops out.

Trelleborg Wheel Systems Page 3 of 3
14. Adjust display position in the holder and tighten up the holder by turning the mounting base collar to
the right as shown on the picture below.
15. Connect the cable of the display holder to the display combi cable (Y-cable) using the securing clip.
16. Ensure that the clip/lug connection is closed securely.