Trent&Steele TS 815 User manual

INSTRUCTION MANUAL
2 SLICE TOASTER
MODEL: TS 815

DESIGN
1. Toast lever
2. STOP button
3. Key REHEAT
4. Key DEFROST
5. Control
6. Full length crumb tray
SAFETY INFORMATION
Please read these Operating instructions through carefully before connecting your
device to the mains, in order to avoid damage due to incorrect use. Please pay
particular attention to the safety information. If you pass the device on to a third party,
these Operating instructions must also be handed over.
Incorrect operation and improper use can damage the appliance and cause injury to the
user.
The appliance may be used only for its intended purpose. No responsibility can be
taken for any possible damage caused through incorrect use or improper handling.
Before connecting the appliance to the power source, check that the current and power
match those given on the rating plate.
Do not put the appliance or the plug in water or any other liquid. However should the
appliance accidentally fall into water, unplug the appliance immediately and have it
checked by a qualified person before using it again. Non-observance could cause a
fatal electric shock!
Never attempt to open the housing yourself.
Do not place any kind of object into the inside of the housing.
Do not use the appliance with wet hands, on a damp floor or when the appliance itself is
wet.
Do not touch the plug with wet or damp hands.
Check the cord and the plug regularly for any possible damage. If the cord or plug is
damaged, it must be replaced by the manufacturer or a qualified person in order to
avoid a hazard.
Do not use the appliance if it is dropped or otherwise damaged or if the cord or plug are
damaged. In the case of damage, take the appliance to an electrical repair shop for
examination and repair if necessary.
Never attempt to repair the appliance yourself. This could cause an electric shock.
Do not allow the cord to hang over sharp edges and keep it well away from hot objects
and naked flames. Remove the plug from the socket only by holding the plug.
For extra protection it is possible to fit the electric household installation with a fault
current breaker with a rated breaking current of not more than 30mA. Ask your
6
1
2
5
3
4

electrician for advice.
Make sure that there is no danger that the cord or extension cord may inadvertently be
pulled or cause anyone to trip when in use.
If an extension cord is used it must be suited to the power consumption of the appliance,
otherwise overheating of the extension cord and/or plug may occur.
This appliance is not suitable for commercial use nor for use in the open air.
Never leave the appliance unattended while it is in use.
Children should be supervised to ensure that they do not play with the appliance.
Because they cannot recognize the dangers involved in the incorrect use of electrical
appliances.
Always remove the plug from the socket when the appliance is not in use and each time
before it is cleaned.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Danger! Nominal voltage is still present in the appliance as long as the appliance is
connected to the mains socket.
Switch the appliance off before disconnecting from the mains.
Never use the cord to carry the appliance.
This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
This appliance is intended to be used in household and similar applications such as:
-staff kitchen areas in shops, offices and other working environments;
-farm houses;
-by clients in hotels, motels and other residential type environments;
-bed and breakfast type environments
Never use the device unsupervised! Switch off the device whenever you are not using it,
even if this only for a moment.
The appliances are not intended to be operated by means of an external timer or
separate remote-control system.
SPECIAL SAFETY INSTRUCTIONS
Caution: Danger of burns! Bread can burn. Do not, therefore, use the toaster near or
below curtains or other combustible materials.
Do not place in the bread slot (7) any oversized baking utensils and bread wrapped in
aluminium foil or plastic foil, because of the risk of burning or electrical shock.
Bring the toast lever in the up position, before pulling out the plug from the socket.
Burning hazard: Parts of the unit become very hot during operation. Touch only the
handles or buttons.
Let the unit cool down before removing or putting in any parts.
Do not try to remove the food from the unit while the unit is still in operation.

Do not use any accessories not supplied with this unit!
This unit is suitable only for toasting bread. Do not heat up any other food with this unit.
Do not ever put in bread with cheese or other spreads in the bread slot (7).
BEFORE FIRST USE
Remove all packing material.
Heat the unit four to five times at the highest setting without bread, in order to burn off
residues left during manufacturing process. Ensure proper ventilation while doing this
(say, by opening the window).
OPERATION
Place bread slices in the bread slot (7). Each bread slot (7) is designed for maximum of
one bread slice per roasting operation.
Connect the main plug to a suitable socket.
You can select the degree of browning by using the controller (4): (1 = light brown, 7 =
well done). The stage 3 is recommended for the first use.
Push down the toast lever (6) fully, till it latches automatically. The check lamp (5) lights
up and the roasting process begins.
The unit will switch off by itself, when the set browning level is reached. The toast lever
(6) jumps up. The bread slices are fully toasted.
Caution: The bread slices and parts of the unit are very hot during and immediately
after the toasting process.
You can change the degree of browning even during the toasting process, by using the
controller (4).
Toasting of deep frozen bread: Place bread slices in the bread slot (7). Set the
controller (4) at the desired degree of browning. Push the toast lever (6) down. Also
press the key DEFROST (2). The LED next to this key light up during the roasting
process. The roasting process starts.
Heating up already toasted bread: Set the controller (4) at the desired degree of
browning. Place bread slices in the bread slot (7). Push the toast lever (6) down. The
roasting process starts. Also press the key REHEAT (1). The LED next to this key lights
up during the roasting process. The roasting process starts.
Bun attachment (9): Use the bun attachment (8) for warming up and roasting buns.
Caution! Never place buns directly on the bread slot.
Fold up the roll attachment completely prior to use. Place it – as shown in the
illustration- onto the toaster, above the toasting slot (7). Place the buns on the bun
attachment (8) and press the toast lever (6) downwards till it clicks into place. You can
remove the buns from the bun attachment when the toast lever springs up. Caution!
The bun attachment becomes very hot.
HOW TO CLEAN THE TOASTER

Your toaster comes with a removable, slide out crumb tray. This is a quick and convenient
way to remove crumbs. Always ensure that the toaster is unplugged and has cooled down
before removing and emptying the crumb tray. Clean the crumb tray with a damp cloth and
always dry the tray properly before replacing it into the toaster.
Use a stiff brush to remove any burnt-on crumbs.
Wipe the outside of the toaster with a damp cloth.
Do not use a sharp object or abrasive substance to clean the toaster.
The appliance is not intended to be operated by means of an external
timer or separate remote-control system.
TECHNICAL SPECIFICATIONS
Operating voltage : 220-240V~50Hz
Power consumption : 780-930W

Table of contents
Other Trent&Steele Toaster manuals