TricLED SLINGSHOT RGB KIT 1 UNDERGROUND HALO User manual
Thank you for your patronage. If you have any questions please contact us at
SLINGSHOT RGB KIT #1UNDERGROUND HALO
Kit #1 Contents:
Alcohol pad, primer, 2 square tabs and
zip tie
(2) 102” RGB strip (tubular frame)
(2) 36” RGB strip (bottom of front spoiler)
(1) 1:2 splitter
(1) 1:6 splitter
(2) 24” extension
(1) 36” extension
Female end is towards the rear, cover
and Zip tie for future use or use with kit
#4 swing arm extension
102” RGB
strip
(2) 36” RGB strip
Install the RGB from
the center and work
towards the outside
connect the (2) 36”
RGB to the 1:2
splitter in the middle
of the front spoiler.
1:2 Y splitter connect to 1:6
using 24” extension 1:6 Y
102” RGB
strip
Use a 36” extension to connect right
side RGB strip to the 1:6 connector
on left side.
Run the 102” RGB along the bottom
round piping of the frame, from front to
back. Test fit first and install in 45 degree
angle out to the outside of the vehicle.
Female end towards the rear for future
extension or Kit #4 extension. From the
front right side RGB, use the 36”
extension to reach the 1:6 splitter. From
left side 102” RGB strip, install the 24”
extension and connect to the 1:6 splitter.
Front spoiler RGB start on the bottom
center and work your way towards the
outside. Test fit first. Connect both RGB
in the center using the 1:2 splitter. Use
the square tab to adhere wire to bottom of
spoiler. Clean with alcohol and use
primer prior to installing square tab.
Using the 24” extension, connect the 1:2
splitter to the 1:6 splitter
Lastly connect the 48” extension to the
opposite end of the 1:6 splitter and run it
up towards the driver side firewall and
make your electrical and remote receiver
connection here into the auxiliary fusebox.
24”
Fuse box
Thank you for your patronage. If you have any questions please contact us at
SLINGSHOT RGB KIT #1 UNDERGROUND HALO
When installing the 102” RGB strip, test
fit from front to back first before
adhering. Clean all surfaces with
alcohol, apply primer when installing on
plastic trim under front spoiler. Use zip
tie along the bottom frame but do not
zip tie tightly or it will damage the RGB
strip. Install the RGB strip along the
tube on it’s side facing the LED towards
the outside of the SS. Doing this will
also prevent damaging the strip in case
it gets bumped on the road or lifted on a
jack. Take your time for a proper and
clean install.
Front left 102”
RGB connection
Front right
connection
Round tubular frame from
front to back on both sides
Rear right side
