Tripp Lite DWTPSC4555M User manual

1
Owner’s Manual
Portrait Flat-Panel
Tilt Wall Mount
(with Security)
Model: DWTPSC4555M
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR
PROPERTY DAMAGE MAY OCCUR!
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2018 Tripp Lite. All rights reserved.
200 x 200 / 200 x 300 /
200 x 400 / 300 x 300 /
300 x 400 / 400 x 400 /
400 x 460
55”
MAX 110 lb.
(50 kg)
MAX
Este manual esta disponible en español en la página de Tripp Lite: www.tripplite.com
Ce manuel est disponible en français sur le site Web de Tripp Lite : www.tripplite.com
Русскоязычная версия настоящего руководства представлена на веб-сайте компании
Tripp Lite по адресу: www.tripplite.com
Dieses Handbuch ist in deutscher Sprache auf der Tripp Lite-Website verfügbar: www.tripplite.com
PROTECT YOUR INVESTMENT!
Register your product for quicker service and ultimate peace of mind.
You could also win an ISOBAR6ULTRA surge protector—a $100 value!
www.tripplite.com/warranty
19-01-428-9338E1-EN.indd 1 1/31/2019 11:26:12 AM

2
NOTE: Read the entire instruction manual before you start installation and assembly.
Warranty & Product Registration
WARNING
• Do not begin the installation until you have read and understood the instructions
and warnings contained in this manual. If you have any questions regarding any
of the instructions or warnings, please visit www.tripplite.com/support.
• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone of good mechanical ability,
with basic building experience and a full understanding of this instruction
manual.
• Make sure that the mounting surface can safely support the combined load of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
• Tighten screws firmly, but do not over-tighten. Over-tightening can damage the
items, greatly reducing their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
5-Year Limited Warranty
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects
in material and workmanship for a period of 5 years from the date of initial purchase. If the product should
prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole
discretion.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE,
ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY
SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES,
INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY
PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL
DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not
allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions
may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from
jurisdiction to jurisdiction).
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate
or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes
no representation or warranty as to the suitability or fitness of these devices for any specific application.
PRODUCT REGISTRATION
Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a
drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
19-01-428-9338E1-EN.indd 2 1/31/2019 11:26:13 AM

3
Component Checklist
IMPORTANT: Ensure all parts according to the component checklist have been received
prior to installation. If any parts are missing or faulty, visit www.tripplite.com/support for
service.
Wall Plate (x1)
M5 x 14 Screw (x4)
Security Bar (x1)
M6 x 6 Screw (x8) Safety Pin (x1) 5 mm Hex Key (x1)D8 Washer (x2) Combo Lock (x1)
Adapter Bracket (x2)
M6 x 14 Screw (x4)
Anchor Bolt (x6)
Washer (x4)
Concrete Anchor (x6)
Small Spacer (x8)
M6 x 30 Screw (x4)
D6 Washer (x6)
Big Spacer (x8)
M8 x 30 Screw (x4) M8 x 50 Screw (x4)
Extension Bracket (x2)
Package M
Package W
19-01-428-9338E1-EN.indd 3 1/31/2019 11:26:13 AM

4
Installation
1. Mount on Solid Brick and Concrete Block
WARNING
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or “cinder block”),
verify that the actual concrete thickness is at least 35 mm (1-3/8”) in order to hold the concrete
anchors. DO NOT DRILL INTO MORTAR JOINTS! Be sure to mount the assembled wall-mount plate
with the included concrete anchors, D6 washers and anchor bolts onto solid sections of the blocks.
The solid sections can generally be found 25 mm (1”) toward the middle of the block from either
end. An electric drill on a slow setting is suggested to drill the hole rather than a hammer drill so
as to avoid breaking out the back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
Concrete
Anchor
D6
Washer
Anchor
Bolt
60 mm
(2.4 in.)
O10 mm
O(3/8 in.)
Find and mark the
exact location of
mounting holes
Drill pilot holes
Screw the
assembled
wall plate
onto the wall
19-01-428-9338E1-EN.indd 4 1/31/2019 11:26:14 AM

5
Installation
2. Attach Extension Brackets to Adapter Brackets
3. Install Adapter Brackets
Extension
Bracket
Adapter
Bracket
With the arrow
pointing up
Top of the
display
M6 x 6
Note: Choose appropriate screws, washers and spacers (if necessary) according to the type of screen.
• Position the adapter brackets as close as possible to the center of the display.
• Screw the adapter brackets onto the display.
Firmly secure all screws. Do not over-tighten.
19-01-428-9338E1-EN.indd 5 1/31/2019 11:26:16 AM

6
Installation
3a. For Flat Back Screen
Note: Choose appropriate screws, washers and spacers
(if necessary) according to the type of screen.
• Position the adapter brackets as close as possible to
the center of the display.
• Screw the adapter brackets onto the display.
Firmly secure all screws. Do not over-tighten.
M5 x 14
Washer Washer
Washer
D6
Washer
D6
Washer
Washer
M5 x 14
M6 x 14
M6 x 14
19-01-428-9338E1-EN.indd 6 1/31/2019 11:26:17 AM

7
Installation
3b. For Non-Standard Back Screen
Note: Choose appropriate screws, washers and spacers
(if necessary) according to the type of screen.
• Position the adapter brackets as close as possible to
the center of the display.
• Screw the adapter brackets onto the display.
Firmly secure all screws. Do not over-tighten.
M8 x 50 M8 x 50 M8 x 50 M8 x 50 M8 x 50 M8 x 50
Washer
Washer Washer Washer
D6 Washer D6 Washer D6 Washer D6 Washer D6 Washer D6
Washer
Washer Washer Washer
Washer Washer Washer Washer Washer
Small
Spacer
Small
Spacer
Small
Spacer
Small
Spacer
Small
Spacer
Small
Spacer
Small
Spacer
Small
Spacer
Big
Spacer Big
Spacer
Big
Spacer
Big
Spacer
Big
Spacer
Big
Spacer Big
Spacer
Big
Spacer
Big
Spacer
Big
Spacer
M6 x 50
M8 x 50
M6 x 50
M8 x 50 M8 x 50 M8 x 50 M8 x 50
19-01-428-9338E1-EN.indd 7 1/31/2019 11:26:18 AM

8
Installation
4. Hang Display onto the Wall Plate
Using an assistant or mechanical lifting
equipment, hook the display with attached
adapter brackets over the top of the mounted
wall plate.
Screw to enable
precision alignment
of multiple screens.
Tighten the screws as shown to fix
the adapter brackets onto the wall
plate in place.
Hex Key
19-01-428-9338E1-EN.indd 8 1/31/2019 11:26:19 AM

9
Installation
5. Slide Security Bar through the Mounting Brackets and Attach
Combo Lock to Secure
Security
Bar
Combo
Lock
Maintenance
• Check that the bracket is secure and safe to use at regular intervals (at least every three months).
• For any additional questions, visit www.tripplite.com/support.
19-01-428-9338E1-EN.indd 9 1/31/2019 11:26:20 AM

10
Installation
6. Adjustment
19-01-428-9338E1-EN.indd 10 1/31/2019 11:26:20 AM

11
19-01-428-9338E1-EN.indd 11 1/31/2019 11:26:20 AM

12
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
19-01-428 93-38E1_RevC
19-01-428-9338E1-EN.indd 12 1/31/2019 11:26:20 AM