Tripp Lite SR4POST User manual

Contents
1-Base (2 Pcs.)1 -Base (2 Pcs.)
2 -Post (4 Pcs.)2 -Post (4 Pcs.)
3-Side lower members (4 Pcs.)3 -Side lower members (4 Pcs.)
4 -Center lower members (2 Pcs.)4 -Center lower members (2 Pcs.)
5 -Side upper members (4 Pcs.)5 -Side upper members (4 Pcs.)
6 -Center upper members (2 Pcs.)6 -Center upper members (2 Pcs.)
7- Top support bracket (2 Pcs.)7- Top support bracket (2 Pcs.)
3/8¨-16 UNF hex nut (32 Pcs.)3/8¨-16 UNF hex nut (32 Pcs.)
3/8¨X 7/8¨ Spring washer (32 Pcs.)3/8¨X 7/8¨ Spring washer (32 Pcs.) * Equipment Hardware
12-24 X 5/8”Cilindrycal head screw (56 Pcs.)
PVC black flat washer (56 Pcs.)
12-24X5/8” Conical screw washer (56 Pcs.)
PVC White flat washer (56 Pcs.)
Cable manager hooks...
(32 Pcs w/mounting fasteners)
12-24 x 5/8 Screw (56 Pcs.)
11
Assemble Base & Posts
* Place base on a hard flat surface. Use 3/8¨
Screws to attach base to each post
22Assemble top support bracket
* Verify alignment
33Pre-Assemble upper and lower
side memebers
* Set desired depth
Use 3/8¨Screws and tighten members
44
55
66Install Cable Manager Hooks as desired
* Use included plastic fasteners
3/8¨-16x1¨UNF screw (32 Pcs.)3/8¨-16x1¨UNF screw (32 Pcs.)
Required Tools
Assembly hardware
9/16¨ Wrench9/16¨ Wrench 9/16¨ Socket, Ratchet9/16¨ Socket, Ratchet
MODEL: SR4POST
ADJUSTABLE OPEN RACK
2424
Assembly Instructions
11
22
33
44
77
55
66
Install Pre-Assembled upper
side members as shown
*Use included nuts .Fasten tightly
Install Pre-Assembled lower side
members as shown
* Verify alignment before tightening
2A. repeat for rear side
1A. repeat for rear side
1111 W. 35th St, Chicago, IL 60609
[phone] www.tripplite.com