Triton Audio FetHead User manual

© 2015 TritonAudio International. All rights reserved.
FetHead
High-end in-line
microphone preamp
USER GUIDE
TRITONAUDIO
Registration Thank you for purchasing a TritonAudio
product. To register your product, please go to:
www.tritonaudio.com/product registration

USER GUIDE
Circuit topology FetHead utilises a low noise jFet
amplier circuit which reveals every detail with pinpoint accuracy
and offers high-end sound quality.
Features
• Low noise Class A JFet amplier
• 27dB amplication (@ 3000Ω Load)
• Balanced xlr input/output
• Lots of headroom
• freq. response 10hz-100khz (+/- 1dB)
• Z-in 22Kohm
• 24-48V phantom power
Dimensions
height: 3’/76mm
width: 0,86’/22mm
FetHead
GENERAL DESCRIPTION
Philosophy FetHead is an ultra low-noise, high quality,
in-line microphone preamplier. It provides improved sound for
Ribbon and Dynamic microphones. Small, compact, but powerful,
Fethead utilizes tried and true FET technology to deliver up to
27dB of clean boost. No more cranking your mic preamp and
adding unwanted noise to get your microphone to an acceptable
volume.
Operation Your Fethead will inconspicuously latch straight
onto any XLR equipped microphone and runs on phantom power,
it’s ready for use with any type of studio setup. Fethead doesn’t
pass phantom power to the microphone, so rest assured your
ribbon mics are safe.
Recommended applications FetHead is
recommended for improving the signal to noise ratio and
performance in the following situations:
• Recording direct into a DAW interface
• noisy or low gain preamps
• mixers/preamps that negatively impact the sound at
higher gain setting
• passive ribbon microphones
• dynamic microphones
• miking all types of softer sound sources