Triumph Speed Triple S User manual

Speed Triple S and Speed Triple RS
This handbook contains information on the Triumph Speed Triple S and Speed Triple RS
motorcycles. Always store this Owner's Handbook with the motorcycle and refer to it
for information whenever necessary.
The information contained in this publication is based on the latest information
available at the time of printing. Triumph reserves the right to make changes at any
time without prior notice, or obligation.
Not to be reproduced wholly or in part without the written permission of Triumph
Motorcycles Limited.
© Copyright 11.2017 Triumph Motorcycles Limited, Hinckley, Leicestershire, England.
Publication part number 3855531-EN issue 1

Maintenance
Scheduled Maintenance Chart
Operation Description Odometer Reading in Miles (Km) or Time Period, whichever comes first
First Service Annual
Service
Mileage Based Service
Every 500 (800)
1 month
Ye a r 6,000 and
18,000 (10,000
and 30,000)
12,000
(20,000)
24,000
(40,000)
Lubrication
Engine and oil cooler - check for leaks Day • • • • •
Engine oil - renew - • • • • •
Engine oil filter - renew - • • • • •
Fuel System and Engine Management
Autoscan - Carry out a full Autoscan using the
Triumph Diagnostic Tool (print a customer copy)
- • • • • •
Fuel system - check hoses for chafing, cracks or
damage - • • •
Fuel system - Check for leaks Day • • • • •
Air cleaner - renew - • •
Throttle bodies - balance - • • •
Fuel hoses - renew Every four years, regardless of mileage
Evaporative loss hoses - renew Every four years, regardless of mileage
Secondary air injection system - check - • •
Ignition System
Spark plugs - check - •
Spark plugs - renew - • •
Cooling System
Cooling system - check for leaks Day • • • • •
Cooling system - check hoses for chafing,
cracks or damage. Replace hoses if necessary - • • •
Coolant level - check/adjust Day • • • • •
Coolant - renew Every 3 years regardless of mileage
Engine
Clutch cable - check function and adjust as
necessary Day • • • • •
Valve clearances - check/adjust - • •
Camshaft timing - check/adjust - • •
Wheels and Tyres
Wheels - inspect for damage Day • • • • •
Rear wheel needle roller bearing - lubricate - • •
Wheel bearings - check for wear/smooth opera-
tion - • • • • •
Tyre wear/tyre damage - check Day • • • • •
Tyre pressures - check/adjust Day • • • • •
Electrical
All lights, instruments and electrical systems -
check Day • • • • •
Steering and Suspension
Steering - check for free operation Day • • • • •

Maintenance
Operation Description Odometer Reading in Miles (Km) or Time Period, whichever comes first
First Service Annual
Service
Mileage Based Service
Every 500 (800)
1 month
Ye a r 6,000 and
18,000 (10,000
and 30,000)
12,000
(20,000)
24,000
(40,000)
Headstock bearings - check/adjust - • • • •
Headstock bearings - lubricate - • •
Front and rear suspension - check for leaks/
smooth operation
Day • • • • •
Fork oil - renew - •
Rear suspension linkage - lubricate - • •
Brakes
Brake fluid levels - check Day • • • • •
Brake fluid - renew Every 2 years regardless of mileage
Brake pads - check wear levels Day • • • • •
Brake master cylinders - check for fluid leaks - • • • • •
Brake calipers - check for fluid leaks and seized
pistons
- • • • • •
ABS and immobiliser ECMs - check for stored
DTCs - • • • • •
Drive Chain
Drive chain - lubricate Every 200 miles (300 km)
Drive chain - wear check Every 500 miles (800 km)
Drive chain slack - check/adjust Day • • • • •
Drive chain rubbing strip - check - • • • • •
General
Engine ECM, Instruments and Keyless ECM -
check for latest calibration download using the
Triumph diagnostic tool
Fasteners - inspect visually for security Day • • • • •
Bank angle indicators - inspect visually for wear Day • • • • •
Side stand/Centre stand - check operation Day • • • • •
Side stand pivot - clean/grease - • • •
Carry out all outstanding Service Bulletin and
warranty work - • • • • •
Carry out road test - • • • • •
Complete the service record book and reset the
service indicator - • • • • •

Maintenance
Suspension Setting Chart - Speed Triple S
Warning
Make sure that the correct balance be-
tween front and rear suspension is
maintained.
Suspension imbalance could signifi-
cantly change handling characteristics
leading to loss of control and an acci-
dent.
Refer to the chart below for further in-
formation or consult your dealer.
Warning
Make sure that the adjusters are set
to the same setting on both forks.
Settings which vary from left to right
could significantly change handling
characteristics leading to loss of con-
trol and an accident.
The standard suspension settings provide a comfortable ride and good handling
characteristics for general, solo riding. The chart shows suggested settings for the
front and rear suspension.
LOADING FRONT REAR
Spring Pre-
Load¹
Rebound
Damping¹
Compression
Damping¹
Rebound
Damping¹
Compression
Damping¹
Solo Riding Road 8 2.5 2 2.5 2
Comfort 8 2.75² 3² 2.75² 3²
Track 8 1 0.5 0.75 0.5
Sport 8 1.5 1.5 1.5 1.5
Rider and Passenger 8 1.5 1.5 1 1
¹ Number of adjuster turns anticlockwise from the fully clockwise position.
² Number of maximum adjuster turns unless already fully screwed out.
Note:
• The Speed Triple S motorcycle is delivered from the factory with the suspension
set at the Road riding settings, as shown in the relevant suspension chart.
Note:
• These charts are only a guide. Setting requirements may vary for rider weight
and personal preferences. See the following pages for information regarding
suspension adjustment.

Maintenance
Suspension Setting Chart - Speed Triple RS
Warning
Make sure that the correct balance be-
tween front and rear suspension is
maintained.
Suspension imbalance could signifi-
cantly change handling characteristics
leading to loss of control and an acci-
dent.
Refer to the chart below for further in-
formation or consult your dealer.
Warning
Make sure that the adjusters are set
to the same setting on both forks.
Settings which vary from left to right
could significantly change handling
characteristics leading to loss of con-
trol and an accident.
The standard suspension settings provide a comfortable ride and good handling
characteristics for general, solo riding. The chart shows suggested settings for the
front and rear suspension.
LOADING FRONT REAR
Spring Pre-
Load¹
Rebound
Damping²
Compression
Damping²
Rebound
Damping²
Compression
Damping²
Solo Riding Road 7 16 19 16 19
Comfort 7 16 26 16 fully an-
ti-clockwise
Track 7 9 9 7 7
Sport 7 11 16 11 18
Rider and Passenger 7 10 12 8 15
¹ Number of adjuster turns clockwise from the fully anticlockwise position.
² Number of clicks anticlockwise from the fully clockwise position noting that the first stop (click) is
counted as one.
Note:
• The Speed Triple RS motorcycle is delivered from the factory with the suspen-
sion set at the Road riding settings, as shown in the relevant suspension chart.
Note:
• These charts are only a guide. Setting requirements may vary for rider weight
and personal preferences. See the following pages for information regarding
suspension adjustment.

Specifications
SPECIFICATIONS
Dimensions, Weights and Performance
A list of model specific dimensions, weights and performance figures is available
from your authorised Triumph dealer, or on the Internet at www.triumph.co.uk.
Payload
Maximum Payload 196 kg (432 lbs)
Engine
Type In-line 3 Cylinder
Displacement 1,050 cc
Bore x Stroke 79 x 71.4 mm
Compression Ratio 12.25:1
Cylinder Numbering Left to Right
Cylinder Sequence Number 1 at Left
Firing Order 1-2-3
Starting System Electric Starter
Lubrication
Lubrication Forced Lubrication (wet sump)
Engine Oil Capacities
Dry Fill 3.5 litres
Oil/Filter Change 3.2 litres
Oil Change Only 3.0 litres
Cooling
Coolant Type Triumph HD4X Hybrid OAT Coolant
Coolant Capacity 2.4 litres
Water/Anti-freeze Ratio 50/50 (premixed as supplied by
Triumph)
Thermostat Opens (nominal) 85°C

Specifications
Fuel System
Type Electronic Fuel Injection
Injectors Solenoid Operated
Fuel Pump Submerged Electric
Fuel Pressure (nominal) 3.5 bar
Fuel
Type 91 RON Unleaded
Tank Capacity 15.5 litres
Ignition
Ignition System Digital Inductive
Electronic Rev Limiter (r/min) 9,500 (r/min)
Spark Plug NGK CR9EIA-9
Spark Plug Gap 0.9 mm
Gap Tolerance +0.00/-0.1 mm
Transmission
Transmission Type 6 Speed, Constant Mesh
Clutch Type Wet, Multi-Plate
Final Drive Chain RK 530 FXW, 108 Link
Primary Drive Ratio 1.75:1 (60/105)
Gear Ratios:
Final Drive Ratio 2.389:1 (18/43)
1st 2.733:1 (15/41)
2nd 1.947:1 (19/37)
3rd 1.545:1 (22/34)
4th 1.292:1 (24/31)
5th 1.154:1 (26/30)
6th 1.037:1 (27/28)

Specifications
Warning
Use the recommended tyres ONLY in the combinations given. Do not mix tyres from
different manufacturers or mix different specification tyres from the same manu-
facturers as this may result in loss of motorcycle control and an accident.
Approved Tyres
A list of approved tyres specific to these models is available from your authorised
Triumph dealer, or on the Internet at www.triumph.co.uk.
Tyres
Tyre Pressures (Cold)
Front 2.35 bar (34 lb/in2)
Rear 2.90 bar (42 lb/in2)
Tyre Sizes
Front Size 120/70 ZR17
Rear Size 190/55 ZR17
Approved Tyres
Electrical Equipment
Alternator 12 Volt, 35 Amp
Battery 12 Volt, 12 Ah
Directional Indicator Lights LED
Headlight 2 x 12 Volt, 60/55 Watt H4 Halogen
Rear Light LED
License Plate Light 12 Volt, 5 Watt Bulb
Frame
Rake 23.0°
Trail 91 mm

Specifications
Tightening Torques
Front Brake Fluid Reservoir Cap Retain-
ing Screws
1 Nm
Fuel Tank Front Fixings 4 Nm
Fuel Tank Front Panel Fixings 2 Nm
Headlight Bracket Bolts 7 Nm
License Plate Bracket Fixing 2 Nm
Oil Filter 10 Nm
Oil Drain Plug 25 Nm
Rear Wheel Eccentric Clamp Bolt 55 Nm
Rider’s Seat Fixings 9 Nm
Spark Plugs 12 Nm
Fluids and Lubrication
Bearings and Pivots Grease to NLGI 2 Specification
Brake Fluid DOT 4 Brake and Clutch Fluid
Coolant Triumph HD4X Hybrid OAT Coolant
Drive Chain Chain Spray suitable for O-Ring Chains
Engine Oil Semi or fully synthetic 10W/40 or
10W/50 motorcycle engine oil which
meets specification API SH (or higher)
and JASO MA, such as Castrol Power 1
Racing 4T 10W-40 (fully synthetic) en-
gine oil, sold as Castrol Power RS
Racing 4T 10W-40 (fully synthetic) in
some countries.