Triumph Trophy Operating instructions

Alarm Fitting and Oper at i ng I struct ions
Trophy .Dayto na. Triden • Trid ent Spri t . Tiger

Alarm Fitting and ~perating Instructions
Kit Contents
Description Qty
Control Box. ................ 1
LED Warning Lamp . . . . . . . . . . 1
M5 Self Tapping Screw . . . . . . . 1
M4 Nuts 4
Warning Label 2
Locknut M5 . . . . . . . . . . . . .. . . . 1
Fitting Ins tr uctions
1. Unlock and remove the motorcycle seat. Remove the tool kit.
2. Disconnect the motorcycle battery, negative lead (black) first.
Description Qty
Speaker 1
Retaining Band 1
Pedestal 2
Flat Washers 2
Screw M5 1
3. On all except Tiger, remove the body side panels from the frame as follows:
a. Unbolt the grab rail (where fitted).
b. Remove the screws securing the side panels to the frame. The side panels are further retained by 4 "push
fit" bayonets on both sides which locate into grommets in the frame. To detach the side panels, support the
panels and gently pull each bayonet horizontally from its grommet.
On Tiger, remove the screws securing the seat end cap to the frame/body and remove the end cap.
Release the screws securing the right hand lower fairing panel to the fuel tank and cockpit. Remove the
panel.

Alarm Fitting and Operating Instructions
4. All except Tiger: To mount the speaker, position in the retaining band with the speaker cone facing to the
rear of the machine. Locate the assembly above the right hand airbox. Ensure that the speaker cannot
chafe against the fuel tank or fuel tank brackets and also that the fuel pipes will not become trapped
between the motorcycle frame and the speaker. Mark the hole position with a pencil and withdraw the
speaker.
CAUTION: Do
not centre punch the hole as this w JII damage the alrbox.
5. All except Tiger: Drill a 2.5mm hole in the airbox, as marked during operation 4, ensuring that no debris
enters the airbox itself.
If\. WARNING: Never use an electric drill near a fuel tank. The sparks from the drJII would Ignite
~ the fuel vapour causing an explos ion and fire. Use a hand drill only.
Refit the speaker and secure in position using the self tapping screw supplied with the kit.
6.
All except Tiger: Locate the white terminal block situated in front of the battery. Remove the blanking
connector from the block and connect the block to the speaker. Position the assembled connector block in
the recess in front of the battery ensuring that the cables will not become damaged when the seat or
bodywork is re-fitted.
NOTE: Retain the blanking connector for future use if the alarm is ever removed. Without the blank, the
engine will not start.
CAUTION: Do not store the blanking connector with the bike as this could reduce the security
provlded by the alarm.

Speaker Fltment
(not Tiger)
Alarm Fitting and Operating Instructions . ~
Ensure wiring does not become trapped