TROJAN PRO Priam User manual

Components:
Z1
Z2
Z3
Z4
Z5
Z6
Z7
Z8
Z9
Z10
Z11
Z12
Z13
A
B
C
D
E
F
G
H
I
Tapping Screw (x24)
Bolt (x22)
Bolt (x6)
Nut (x6)
Eccentric Nut (x32)
Derrick Screw (x32 )
Dial Pad (x8)
Feet Pad (x2)
Support Bracket (x3)
TYPE-R (x32)
Dial Wheel (x2)
Rail (x2)
4U Rack Strips (x4)
Mid-Leg Support (x1）
Left-Leg Support (x1）
Right-Leg Support (x1）
Rear Brace Support (x1）
Work Surface (x1）
Upper Shelf (x1)
Junction Plate (x4)
Speaker Tray (x2）
Keyboard Tray (x1)
Assembly Instructions
Studiospares Europe Ltd. 19 Bilton Way, Luton LU1 1UU, UK
www.studiospares.com [email protected] [phone]

CAUTION
FAILURE TO OBSERVE PROPER ASSEMBLY INSTRUCTIONS, EXCEEDING THE WEIGHT CAPACITY
OR FAILURE TO OBSERVE THE WARNINGS AS MENTIONED IN THIS INSERT MAY CAUSE STAND TO
COLLAPSE, BODILY INJURY OR EQUIPMENT DAMAGE AND WILL VOID THE PRODUCT WARRANTY.
Assembly Instructions BEFORE YOU BEGIN: Make sure that you have a clear area before
beginning assembly. Remove all contents from the box and
identify the parts using these diagrams.
A
A
I
1. Screw 2 x Foot Pads (Z8) to Mid-Leg Support (A) 6. Attach Mid-Leg Support (A) using Derrick
Screws (Z6) and Eccentric Nuts(Z5).
7.Add Derrick Screws (Z6) to Work Surface (E)
8.Attach Work Surface (E) to assembly using
Derrick Screws (Z6).
9.Add Derrick Screw (Z6) to top of Work
Surface (E).
2. Attach Rail (Z12) to Left-Leg Support (B) using
3. Attach Rail (Z12) to Right-Leg Support (C) using
4. Fasten the Rear Support Brace (D) using Derrick
Screws (Z6).
5. Attach left and right leg supports to each end of
Rear Brace Support using Derrick Screws (Z6)
and Eccentric nuts (Z5)
C
B
D
E
10.Connect two sets 4U rack strips (Z13)
Junction Plates (G) using Tapping Screws(Z1)
11.Attach Junction Plates (G) to Work
Surface (E) using Eccentric Nuts(Z5)
12.Attach Dial Pad (Z7) using Tapping Screws(Z1)
Install Dial Wheel (Z11) use Bolt.(Z2)
13.Connect Speaker Tray (H) using 4pcs Bolt (Z2)
in the upper holes of Upper Shelf.
14.Add Derrick Screws (Z6) to Upper Shelf (F)
15.Connect Upper Work Shelf (F) on to
Junction Plate using Eccentric Nuts(Z5).
16. Attached Support Brackets (Z9)
using Tapping Screws(Z1).
17.Install Keyboard Tray(I) with Rails(Z12)
using Bolts(Z3) and Nuts(Z4)
18.Apply TYPE-R ( Z10) protection pads to
cover Eccentric nuts (Z5).
E
G G
GGGG
H
I
F