Troy-Bilt 11A-542Q711 Guide

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Lea el manual de operación anexo sobre ensamblaje e inicio.
© 2007 11A-542Q711 778-10940C
Move hairpin clip to inside hole. Insert carriage bolt
and tighten with wing nut. Repeat on opposite side.
Secure cable to lower handle with cable tie
provided with unit.
Lift handle to extended position.
Tighten star knobs.
Starter
Rope
Blade Control Handle
Star Knobs
1
2
3
4
B
A
Hold blade control handle against upper handle.
Slowly slip starter rope into rope guide.
Tighten rope guide wing knob.
C
B
A
D
A
B
Refer to Operator’s Manual for instructions on attaching the grass catcher.

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Depress blade control handle and hold. The choke will
move slowly to OFF position – immediately proceed to
step 9 below.
Pull starter rope with quick, full armstroke. If engine
does not start after ten seconds of repeated pulls, wait
a few minutes and repeat steps 7b through 9.
9
8
Fill tank with gas to within 1/2 inch of top of tank.
Open fuel valve (a) and activate choke (b).
5
Choke
6
7
Oil Fill
Gas Cap
Fuel Valve
Fill engine with oil to upper limit of dipstick. Check
oil level by inserting (and not threading) dipstick
into ller neck.
ab