
That should do it! We hope you enjoy your FORUM Table.
If you have any questions or need assistance, feel free to
reach us at 888-474-7977 or at info@trueformconcrete.com.
PAGE 2 of 2
Placing the Top OVERHANG DIMENSIONS
FORUM CONCRETE TABLE
INSTALLATION INSTRUCTIONS
SKU: TBL-FORUM-DIN
Place the top on the legs, centering it as well
as you can by eye. Once the top is on, make
small adjustments by lifting/nudging the top
until it is in the correct position using the
OVERHANG DIMENSIONS to the right. Verify
the overhang is correct on all sides using a
measuring tape.
Using a power drill with a Phillips-Head bit,
drives screws through each of the 8 mounting
brackets and into the wooden subdeck. You
may wish to tighten with a Phillips-head
screwdriver to avoid stripping the pilot hole.
Note: If the table needs to be moved at any
point, it is strongly advised to detach the
table top and move the pieces separately.
14 24
14
14
15.5 32
16.5 42
14
22.5 42
14
84 x 44
95 x 44
107 x 44
119 x 44