TRUEFORM TBL-AURA-RND-C User manual

AURA CONCRETE TABLE
INSTALLATION INSTRUCTIONS
Thank you for choosing Trueform Concrete.
AURA is a minimalist concrete table designed
to provide unobstructed leg room.
8 stainless steel panhead screws, 3/4” long
SKU: TBL-AURA-RND-C
Power drill
Phillips-Head bit
Phillips-Head screwdriver
Level
Measuring Tape
Hardware Provided Items Required
This table was shipped in separate pieces in order to prevent damage from transit. Light assembly is
therefore required. Caution: These pieces are heavy, so assembly will require at least two people.
For the best results, please read these instructions in their entirety to understand the complete
process before you begin.

1. Place the concrete base in its intended location. The bottom of the base has adjustable feet to
accommodate for uneven flooring. Adjust each of the feet by turning them either clockwise or
counter-clockwise, checking with a level until the base is level both vertically and horizontally.
That’s it! We hope you enjoy your AURA Table. If you have any
questions or need assistance, feel free to reach us at
888-474-7977 or at [e-mail].
If you have purchased a custom-sized AURA, simply follow
the directions above while using the overhang dimensions
provided in your technical drawing.
Setting & Leveling the Base
2. The underside (subdeck) of the top has been predrilled to
accept screws. One location will be marked with a colored
circle that corresponds to a similar mark on one of the 4
brackets. This is done to ensure the top is orientated
properly and the holes align with the brackets. Identify
these marks on both the top and base.
3. Place the top on the base so that location of the two
colored dots align while centering it as well as you can by
eye. Once the top is on, make small adjustments until the
holes and brackets align by measuring the overhang on all
sides using values in the charts to the right. The 60” table
has an 18“ overhang while the 48” & 54” tables have a 15“
overhang. Ensure the top is centered over the base.
4. Using a power drill with a Phillips-Head bit, drive screws
through the holes in each of the 4 mounting brackets and
into the wooden subdeck. You may wish to tighten with a
Phillips-head screwdriver to avoid stripping the hole.
Placing the Top
For Custom Sizes
AURA CONCRETE TABLE
INSTALLATION INSTRUCTIONS
SKU: TBL-AURA-RND-C
BASE
AURA 60”
AURA 54”
AURA 48”
BASE
BASE
18”
18”
15”
15”
15”
15”