Gracious Home GH3015CR-WH User manual

Page 1
WARNING!
Children have died from furniture tip over. To reduce the risk of furniture tip over:
ALWAYS install anti-tipping hardware that is provided.
NEVER allow children to stand, climb or hang on drawers, doors, or shelves.
NEVER overload shelves or drawers - evenly distribute the weight.
!
Gracious Home 15'' x 30'' Corner Closet
ASSEMBLY INSTRUCTIONS
These assembly instructions are only applicable for the 15'' x 30'' Corner Closet.
General Instructions:
Thank you for purchasing a Gracious Home product. You are now the proud owner of a high quality
product designed to face the test of daily use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly. please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the manufacturer warranty. The
manufacturer will decline any responsibility for any damages caused. Any installation which does not
correspond to the instructions may result in defects. malfunctioning parts. significant damage and/or
injury.
If you are missing any parts, please contact Customer Care department immediately .
Important:
Weight Capacity - Overall Unit 100 1bs.
Each shelf has a maximum capacity of 30 1bs.
Tools Required: Phillips Screwdriver Tools Required: Electric Drill Tools Required: Rubber Mallet

A
C
I
F
E
J
D HG
NO.
A
B
C
D
E
F
G
H
ITEM
Right Side Panel
Back Rail
Left Side Panel
Bottom Panel
Shelf
Back Panel
Toe Kick-1
Toe Kick-2
Hardware Bag
Page 2
a b
g
Qty 26 Q
ty 26 Q ty180
e
Qty 26
f
Qty 24
Qty 30
cd
Qty 30
h
Qty 1
i
Qty 4
j
Qty 2Qty 4
k
QTY
1
3
1
1
5
1
1
1
GH3015CR-WH
GH3015CR-WN
B
ITop Panel 1
J
Left Back Side Panel
1

W ork on soft surface s
Soft Surface
Hard surface
After unpacking, place the panels on a soft surface.
Screw the hardware onto the side panel with an electric drill.
Page 3
a
Qty
26
A
J
C
GH3015CR-WH
GH3015CR-WN

Install the wooden dowels on the top, bottom panel, back rail and
toe kick with the rubber mallet .
Then connect with the left back side panel.
Tighten it with a screwdriver, and Insert the back.
Page 4
b
Q ty 9
B
I
D
F
f
Qty 24
GH3015CR-WH
GH3015CR-WN

Fasten the left side panel and the right side panel with a
screwdriver, paste perfect paste to the hole.
Page 5
b
Qty 17
e
Qty 26
GH3015CR-WH
GH3015CR-WN
C
A
H
G

Place the removable shelf into the cabinet,the total quantity is 5 PCS
GH3015CR-WH
GH3015CR-WN
Page 6
E

Install the shelf pins (c) in the desired shelf positions using an
electric drill. Place the adjustable shelves on the pins. After they
are all located, lock the cam locks to secure the shelves in place.
Insert the plastic pins (g) in the rest of the unused shelf holes.
Qty 30
cg
Qt
y180
GH3015CR-WH
GH3015CR-WN
Page 7

Use the drill to make through hole
h
Qty 1
GH3015CR-WH
GH3015CR-WN
Page 8
When placing two cabinets next to each other use below
hardware to connect the two cabinets for extra strength
Drill a hole in the two side panels that are next to each other then
secure the colset with the screw through the hole

i
Qty 4
GH3015CR-WH
GH3015CR-WN
Page 9

Cabinet
Wooden walls
1
2
3
Top Panel
GH3015CR-WH
GH3015CR-WN
Page 10
j
Qty 2
Anti-tipping hardware kits are
included to secure the closet to the
wall. If there is not a stud in the
wall to secure the hardware, use
the wall anchor for support and
attach both of the hardware to the
top panel and wall evenly
distributed for weight bearing.
Hardware Bag
5x60 SCREW AND
ANCHORS TO WALL
4x16 SCREW TO CABINET