Truma MonoControl CS User manual

Operating instructions Page 2
To be kept in the vehicle!
MonoControl CS Gastank

2
Table of Contents
Symbols used ........................................................................ 2
Intended use .......................................................................... 2
Safety instructions ............................................................ 3
Operating instructions
Start-up ................................................................................ 4
Checking for leaks in the high-pressure section ......... 4
Checking for leaks in the low pressure section ........... 4
Maintenance ....................................................................... 5
Accessories ......................................................................... 5
Technical data ................................................................... 5
Manufacturer’s Warranty
(European Union) ................................................................ 6
MonoControl CS gas tank
Symbols used
The unit may only be installed and repaired by an
expert.
Symbol indicates possible hazards.
Note containing information and tips.
Intended use
MonoControl CS is a safety gas pressure regulation system
for caravans and motor homes. The gas tank version is for
direct connection to the extraction valve with a male thread
W21.8x1/14 LH (G.5). The gas pressure regulation system
ensures a uniform output pressure of 30 mbar with a permis-
sible admission pressure of 0.3 – 16 bar.
The integrated crash sensor interrupts the flow of gas in the
event of an accident with deceleration of 3.5
g ± 0.5 g * act-
ing directly upon the triggering element.
* With an average vehicle weight, this corresponds to a colli-
sion speed of approx. 15 – 20 km/h with a fixed obstruction.
The integrated overpressure safety device complies with the
requirements for a commercial safety device against excess-
ively high pressure increases (for example, in Germany ac-
cording to DGUV regulation 79 – previously BGV D 34).

3
MonoControl CS gas pressure regulation system with over-
pressure safety device S2SR (OSD) is a two-stage regulator. If
one of the two regulator stages fails, e.g. due to dirt or other
foreign matter on the valve, the other regulator stage reduces
the pressure to a maximum of 150mbar.
Using the MonoControl CS in closed rooms (e.g. at home), on
boats or in EX Zone 0 (e.g. tankers) is prohibited.
The national regulations must be observed if there is a possi-
bility of it being used in mobile homes. In Germany, its use in
mobile homes is prohibited.
Safety instructions
– The use of gas tanks from which gas is extracted in the gas
phase is mandatory when operating the MonoControl CS
gas pressure regulation system. Gas tanks from which gas
is taken in the liquid phase (e.g. for forklifts) must not be
used, since they would result in damage to the gas system.
– Pressure regulation devices and hoses must be replaced
with new ones no more than 10 years after their date of
manufacture (every 8 years if used commercially). The oper-
ator is responsible for this.
Operating the gas system while driving
– The device manufacturer’s instructions must be followed
before operating a liquid gas device while driving.
– For heating while driving, the regulation (EC) No. 661/2009
and the binding UN/ECE regulation R 122 stipulate a safety
shut-off device for motor homes and caravans.
The Truma MonoControl CS gas pressure regulation system
satisfies this requirement.
Installing a safety shut-off device such as the Truma
MonoControlCS gas pressure regulation system with
appropriately configured gas installation means that a
type-tested liquid gas heater may be used in line with the
aforementioned regulation while driving throughout Europe.
National regulations and rules must be followed.
– For vehicles manufactured before 01/2007 there are no re-
strictions for operating the gas system while driving **.
** Except for France:
In France, operation of a gas system while driving is only
permitted in type-tested vehicles with first registration as
of 01.01.2007. In older vehicles the operation of the gas
system while driving is also non-permissible in combination
with a safety shut-off device.

4
Checking for leaks in the low pressure
section
(maximum test pressure 150 mbar)
The test must be conducted by a technician!
– Turn off all consumers.
– Open stop valves and, if present, the gas remote switch.
– Remove the threaded cap from the test connection (b) and
connect the test pump with test hose to the test connection.
b
Figure 2
– Carry out the check for leaks (e.g in Germany in accordance
with G 607).
– If the gas system leaks, close the extraction valve and have
the gas system repaired immediately by an expert. Do not
open the extraction valve until repair is complete.
– When testing is complete, screw the threaded cap back
onto the test connection.
Operating instructions
Start-up
Open the gas remote switch if present.
1. Open the extraction valve.
2. If necessary (e.g. after a new installation), firmly press the
green reset button (crash sensor triggering element reset)
on the the MonoControl CS gas tank for about 5 seconds.
2.
1.
Figure 1
Checking for leaks in the high-pressure
section
The screw joints must be tested for leaks using suitable
means (such as a leak-finder spray in accordance with
EN 14291).
The operator is responsible for this.

5
Maintenance
The MonoControl CS gas pressure regulation system is
maintenance-free.
In Germany, the gas system must be retested every 2 years by
a liquid gas specialist (DVFG, TÜV, DEKRA). The test must be
confirmed on the respective test certificate (G 607).
In countries where testing is not mandatory, we recommend
that the gas system is tested every 2 years for your own safety.
Pressure regulation devices and hoses must be replaced with
new ones no more than 10 years after their date of manu-
facture (every 8 years if used commercially). The operator is
responsible for this.
Accessories
EisEx regulator heating
(part no. 53101-01)
Gas remote switch
for turning off the gas supply from inside the vehicle
GS 8 (part no. 57014-01)
GS 10 (part no. 57024-01)
Straight reducer Z 10 / RVS 8
(part no. 50020-04000)
MUV changeover valve
MUV 8 for 8 mm gas pipe (part no. 25131-01)
MUV 10 for 10 mm gas pipe (part no. 25141-01)
Technical data
(determined in accordance with EN 16129:2013 or Truma test
conditions)
Type of gas
Liquid gas (propane / butane)
Admission pressure
0.3 – 16 bar
Output pressure
30 mbar
Regulator capacity
1.5 kg/h
Regulator inlet
Union nut W 21.8x1/14 LH (G.5)
Regulator outlet
30mbar 10 mm (H.9)
Horizontal triggering value
3.5
g ±0.5 g
Operating temperature
-20 °C to +50 °C
Product ID number
CE-0085BQ0102
DG approval number: 3894
Subject to technical changes.

6
Manufacturer’s Warranty
(European Union)
1. Scope of Manufacturer’s Warranty
As the Manufacturer of the unit, Truma undertakes a warranty
towards the Consumer that covers any material and/or manu-
facturing defects of the unit.
This Warranty is applicable in EU member states as well as in
Iceland, Norway, Switzerland and Turkey. A Consumer is the
natural person who was the first one to purchase the unit from
the Manufacturer, OEM or dealer and who neither resold the
unit in a commercial or self-employed professional capacity
nor did he or she install it for a third party in such a capacity.
The Manufacturer’s Warranty covers any of the aforementioned
defects that occur within 24 months upon concluding the
purchase agreement between the seller and the Consumer.
The Manufacturer or an authorised service partner undertakes
to remedy such defects through subsequent fulfilment, i.e.
at its discretion either by repairing or replacing the defective
item. Any defective parts shall become the property of the
Manufacturer or the authorised service partner. If the unit is
no longer manufactured at the time of defect notification and
if replacement delivery has been opted for, then the Manufac-
turer may deliver a similar product.
If the Manufacturer remedies a defect under its warranty com-
mitment, the term of the Warranty shall not recommence anew
with regard to the repaired or replaced parts; rather, the origi-
nal warranty period shall continue to be applicable to the unit.
Only the Manufacturer itself and an authorised service partner
shall be entitled to conduct a warranty job. Any costs that
occur in the event of a warranty claim shall be settled directly
between the authorised service partner and the Manufacturer.
The Warranty does not cover additional costs arising from
complicated removal or installation jobs on the unit (e.g. dis-
mantling of furnishings or parts of the vehicle body), and nei-
ther does it cover travel expenses incurred by the authorised
service partner or the Manufacturer.
No further-reaching claims shall be permitted, especially dam-
age claims presented by the Consumer or third parties. This
provision shall not affect the validity of the German Product
Liability Act (Produkthaftungsgesetz).
Neither does the voluntary Manufacturer’s Warranty affects
the Consumer’s legally applicable claims for defects towards
the seller in the relevant country of purchase. In individual
countries there may be warranties that can be issued by the
relevant dealer (official distributor, Truma Partner). In such
cases the warranty can be implemented directly through the
dealer from whom the Consumer bought the unit. The warran-
ty regulations of the country in which the unit was purchased
by the Consumer for the first time shall also be applicable.
2. Warranty exclusions
No warranty claim shall be applicable under the following
circumstances:
– Improper use, contrary to the specified use
– Improper installation, assembly or commissioning, contrary
to operating or installation instructions
– Improper operation, contrary to operating or installation
instructions, particularly maintenance, care and warning
notes
– Instances where repairs, installations or any other proce-
dures have been conducted by non-authorised partners
– Consumable materials and parts which are subject to natu-
ral wear and tear
– Installation of replacement, supplementary or accessory
parts that are not original Manufacturer’s parts and which
have thus caused a defect

7
– Damage arising from foreign substances (e.g. oils, plasti-
cisers in the gas), chemical or electrochemical influences
in the water, or cases when the unit has come into contact
with unsuitable substances (e.g. chemical products, unsuit-
able cleaning agents)
– Damage caused by abnormal environmental or unsuitable
operating conditions
– Damage caused by force majeure or natural disasters or
any other influences not within Truma’s responsibility
– Damage resulting from improper transport
3. Making a warranty claim
The warranty must be claimed with an authorised service part-
ner or at the Truma Service Centre. All the relevant addresses
and phone numbers can be found at www.truma.com, in the
“Service” section.
To ensure a smooth procedure, we should be grateful if you
could have the following details ready before contacting us:
– Detailed description of the defect
– Serial number of the unit
– Date of purchase
The authorised service partner or the Truma Service Centre
will then specify the further procedure. To avoid transport
damage, the affected unit must only be shipped upon prior
arrangement with the authorised service partner or the Truma
Service Centre.
If the warranty claim is recognised by the Manufacturer, then
the transport expenses shall be borne by the same. If no
warranty claim is applicable, the Consumer will be notified ac-
cordingly and any repair and transport expenses shall then be
the Consumer’s liability. We must ask you not to send in a unit
without prior arrangement.

Las instrucciones de uso y de montaje en su idioma pueden
solicitarse al fabricante Truma o al Servicio postventa Truma
en su país.
Saat käyttö- ja asennusohjeen pyynnöstä omalla kielelläsi
valmistajalta (Truma) tai maasi Truma-huoltoon.
Μπορείτε να ζητήσετε τις οδηγίες χρήσης και τοποθέτησης
στη γλώσσα της χώρας σας από τον κατασκευαστή Truma ή
από το σέρβις της Truma στη χώρα σας.
Návod k použití a montáži si lze v jazyce vaší země vyžádat
uvýrobce Truma nebo servisu Truma ve vaší zemi.
Návod na použitie a montáž vo Vašom štátnom jazyku si
môžete vyžiadať u výrobcu Truma alebo v servise Truma vo
Vašej krajine.

Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Straße 12
85640 Putzbrunn
Deutschland
Service
Telefon [phone]
Telefax [phone]
[email protected]
www.truma.com
01 491-84 / 50020-67900 · 05 · 10/2017 ·
Bei Störungen wenden Sie sich bitte an das Truma
Servicezentrum oder an einen unserer autorisierten
Servicepartner (siehe www.truma.com).
Für eine rasche Bearbeitung halten Sie bitte Gerätetyp und
Seriennummer (siehe Typenschild) bereit.
Should problems occur, please contact the Truma Service
Centre or one of our authorised service partners
(see www.truma.com).
In order to avoid delays, please have the unit model and
serialnumber ready (see type plate).
Veuillez vous adresser au centre de SAV Truma ou à un de
nos partenaires de SAV agréés en cas de dysfonctionnements
(voir www.truma.com).
Pour un traitement rapide de votre demande, veuillez tenir
prêts le type d’appareil et le numéro de série (voir plaque
signalétique).
In caso di guasti rivolgersi al centro di assistenza Truma o a
un nostro partner di assistenza autorizzato (consultare il sito
www.truma.com).
Affinché la richiesta possa essere elaborata rapidamente,
tenere a portata di mano il modello dell’apparecchio e il
numero di matricola (vedere targa dati).
Bij storingen kunt u contact opnemen met het Truma
Servicecentrum of met een van onze erkende servicepartners
(zie www.truma.com).
Voor een snelle bediening dient u apparaattype en
serienummer (zie typeplaat) gereed te houden.
Ved fejl kontaktes Trumas serviceafdeling eller en af vores
autoriserede servicepartnere (se www.truma.com).
Sørg for at have oplysninger om apparattype og serienummer
(se typeskiltet) klar for hurtig behandling.
Vid fel kontakta Truma servicecenter eller någon av våra
auktoriserade servicepartner (se www.truma.com).
För snabb handläggning bör du ha aggregatets typ och
serienummer (se typskylten) till hands.
©