GB
Quick Start Guide
SC01002 TTS Group Ltd., Park Lane Business Park,
Kirkby-in-Ashfield, Nottinghamshire, UK NG17 9GU
TTS Basic Stopwatch
Changing The Batteries
The stopwatch requires 1 x CR2032 lithium battery (supplied). Undo the screw to release
the battery hatch using a small screwdriver. Carefully slide the battery hatch out and lift the
exhausted battery from the battery housing. Insert the new battery carefully, making sure it
is fitted with the correct polarity. Re-fit the battery hatch and re-tighten the screw.
Sleep Mode
When the stopwatch is not in use they will automatically enter sleep mode to conserve the
batteries. Press any button to resume operation. Stopwatch will enter sleep mode after 5
minutes of inactivity.
Changing the Display Mode
The display has been configured can be configured to show time in 3 different modes:
Using Your Stopwatch
Important Information
Please retain the information in this User Guide for future reference.
Please read all instructions fully before using.
To clean, wipe the product with a clean damp cloth.
Do not allow the product to come into contact with water or other liquids.
Keep the product away from direct sunlight and heat.
If your product malfunctions please switch it off and then back on again to reset it.
Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short-circuited.
Only batteries of equal size and type should be used.
Reset Button
Digital Display
Start/Stop Button
Lanyard
Know Your Stopwatch
www.ttsgroupsupport.com
88’88”
88’88” 8
88’88” 88
To change the display mode, use a paper clip to toggle the concealed mode button next
to the start/stop button (see Know Your Stopwatch). Each time the button is pressed the
display will change mode.
minutes and seconds
minutes, seconds and 1/10 seconds
minutes, seconds, 1/10 and 1/100 seconds
Mode
Specification
Battery type 1 x CR 2032 Coin Cell