6
to the inside. Pull the cable through so that there is a small amount of slack and you can still move the
Camera around the license plate.
4. Locate the reverse taillights wiring behind your reverse light. You may need to remove the interior
panel in order to locate. You only need to attach the Camera to ONE of the reverse lights, not both. If
you cannot manually locate the taillight cables, please contact the vehicle manufacturer or reference a
wiring diagram for your vehicle.
5. At your taillight, remove the light bulb socket from the reverse light housing.
6. Determine the reverse light power wires for your car, designating the positive and negative wires.
If you are not sure of which are the power wires, then please contact your vehicle manufacturer or
reference a wiring diagram for your vehicle.
7. Connecting the Camera Power Cable:
a. Take the open wire end of this cable, and connect it to the power wires of your car (as
determined in step 4). Using the Snap Lock Splice Connectors, connect the Camera’s Red wire
to reverse light’s Positive wire. Connect the Camera’s Black Wire to reverse light’s Negative
wire.
b. Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a solid
connection, then snap the plastic cover closed.
8. While sitting in the driver’s seat of the car with the key in the accessory position, open the TYPE S Drive
App on your smart phone and go to FHD Backup Camera section.
9. Put the vehicle in reverse. If you can see clear picture on the app screen, put the vehicle back in park
and turn the key to the o position. You are now ready for nal steps.
10. If you cannot see any image on the app view when you place your vehicle in reverse position, open the
WiFi setting page of your smart phone and make sure it is connected to“TYPE S Backup Camera WiFi”
directly (please refer to page 7 on setting up the app).
11. Use the provided zip ties to secure wires neatly within your car.
12. Replace the light socket back into the reverse light housing.
13. Replace any interior panels that may have been removed to access the taillight and close your trunk or
rear hatch.
