;
;
during measurement.
(See Figure 6)
E.Measuring Frequency (See Figure 7)
F.Measuring DC Current (See Figure 8)
into
4. Press the lever to open the transformer jaw, hold it tight and don't release.
The built-in components are very sensitive not only to the magnet but also to
heat and mechanical force. Any shock will cause change to the reading in the
short time.
5. the lever
cause ± 1%
measure
To obtain a more accurate DC current reading, follow the procedure as below:
1. Turn off the current to the tested conductor.
2. Press the lever to open the transformer jaw, and center the conductor within
the transformer jaw.
4. Turn on the current to the tested conductor, read out the reading after the
Meter is stable.
3. .
5.
Figure 9
DC current
G.Measuring AC Current (See Figure 9)
2. Press the Lever to open the transformer jaw, hold it tight
and don't release. The built-in components are very
sensitive not only to the magnet but also to heat and
mechanical force. Any shock will cause change to the
reading in the short time.
cause
measure
3.
AC Conversion:
UT209: AC-coupled and True RMS responded. Input the sinewave.
Non-sine
AC current
section.
Pressing
Technical Specifications
Low Battery Indication:
Opening:
Safety/ Compliances: IEC 61010 CAT. II 600V, CAT. III 300V,
Double Insulation and Pollution Degree 2.
Accuracy Specifications
Non-sine
AC Conversion:
UT209: AC-coupled and True RMS responded. Input the sinewave.
Maintenance
(See Figure 10)
P/N: 110401104374X
MAY.2018 REV. 4
