Unicol ADAPTA-WALL VWP0 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
VWP0 / VWP1 / VWP2 / VWP3 / VWP4 / VWPHD
Screen Size: 33-90” Guide Max. Weight: 45-80kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1Pop-Out Mount Body 1
2Adjustable Mount Arms 2
#TOOLS REQUIRED
1 n/a
12

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
Measure the width and height of the screen(s) to be installed. On the wall, mark out a grid as shown above.
Position each mount so that the centreline guides line up exactly with the arrows on the mount body.
STEP 2
Using the identified mounting slots, fix the mount
to the wall.
Please consider cabling and wall fixings prior to
installation. Please check surface is capable of
supporting 5x the combined solutions weight.
STEP 3
Utilising the fixing pack provided with your mount,
attach the arms to the back of your screen.
Ensure the arms are the correct way up before
tightening - the ‘hook’ part of the arm should be at
the top.
HALF SCREEN WIDTH FULL SCREEN WIDTH
FULL SCREEN LENGTH
HALF
LENGTH

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 4
Using another team member, lift the screen up and
gradually offer it up to the back plate. Gently tilting
the screen forward, hook the arms over the lip of
the back plate and lower once in position.
Centre the screen horizontally by sliding from side
to side until you are happy with the position. Lock
the arms in place by turning the locking lever 90o.
STEP 5
Genlty push on the centre bezel of the screen in
order to pop the mount out. Alternatively, utilise the
optional pop out mechanism pull cord. Cable up.
STEP 6
For fine adjustment (up/down and in/out) use the
hand adjustable screws on each arm. Make micro
adjustments to ensure each screen is level with
each other or within an alcove.