Unicont SPb Ltd Operating manual MV-1504/1704/1904/2104
Page 10
5. CONTROLS
Dimmer (Backlight)
Set Button (to apply
changed parameters and
to access menu items)
Menu Access Button
Power LED
Setting Selection
and Change Buttons
Display Power on/off
Button
(to choose
video signal sources)
The following controls are located on the front panel:
1. Display Power on/off button (short-time pushing switches the display over cycle-wise
according to the video signal sources).
2. “MENU”. Enter/exit button to access the display settings menu. When in the menu, this
button allows to exit the active setting without saving the changed parameter.
3. “▲” and “▼”. Selection buttons to select a menu item/parameter measurement. When in
the menu, this buttons allow to scroll up the items (settings) up and down. If any setting is changed,
they are used to increase/decrease its value.
4. Dimmer to control the backlight intensity. Turn it up to the stop in direction right to
maximize the backlight intensity. Turn it up to the stop in direction left to cancel it (no backlight).
5. Power LED shows that power is available and the device is operating. If power is on and
video signals are received from the current video input, this LED is green. If power is off or no video
signal available in the current input, the LED goes out.
Warning! Changing backlight intensity automatically and correspondingly changes the LED-
light intensity. If it is in the minimum (backlight cancelled), the LED will go out.
