UniGuard UT07 User manual

www.uniguardgps.com
UniGuard Technology Limited
UT07/UT07L OBD GPS Tracker
User Manual
(Version V1.0)
Thank you very much for using GPS TRACKER, the user manual will guide how to operate this
product, please read it carefully before using it in order to get the correct method of operation. If
the appearance, color and accessories of this product are modified, please refer to the actual
product. The manufacturer is not liable for faults and omissions which in the user manual.

www.uniguardgps.com
UniGuard Technology Limited
1
、
Product functions & Parameters
1.1 Product functions
Location inquiry, geo-fence, over-speed alarm, power-off alarm, historical route playback,
voice monitoring
1.2 Parameters
●UT07 2G Frequeny: 850/900/1800/1900 Mhz;
●UT07L 4G Frequeny: LTE FDD: B1/2/3/4/5/7/8/28/66 and 850/900/1800/1900 Mhz;
●Wide voltage input range: 8 - 24V;
●Location time: average warm start:≤3sec(open sky)
Average cold start:≤35sec(open sky)
●Device dimensions:42mm × 28mm × 17mm;
●Location accuracy:≤10 meters;
●Working Temp:-20℃ - 75℃
●Backup battery: 200mAh
2
、
Product accessories and LED light status
2.1 Accessories:
Standard: device, user manual
2.2 Device LED light status
2.2.1 Yellow LED (GSM signal status)
Light status
Meaning
Flash every 2 seconds
GSM initialization
on
GPRS normal communication/online
off
GSM sleep/power off
2.2.2 Blue LED (GPS signal status)
Light status
Meaning
Flash every 2 seconds
GPS signal searching
on
GPS location finished
off
GPS sleep/power off
3
、
Installation instructions
3.1 Preparation before installation:
1, Open the box and check whether the device and the accessories are complete, otherwise please
contact your dealer.
2, SIM card selection, the device works with Micro SIM card, and support full Netcom band.
3, SIM card installation, SIM card corner inside, chip face to the side with shrapnel, which can help
to hold the card.
Note: (1) Before installing or removing the SIM card, please switch off the device;
(2) Should activate the GPRS function of the SIM card;

www.uniguardgps.com
UniGuard Technology Limited
(3) Should activate the caller ID function; (activate or not according to the
functions you chose.)
(4) If your SIM card required you to input the SIM PIN, please refer to your
mobile phone user manual to turn off the SIM PIN function.
(5) Please ensure that the SIM card is valid.
3.2 Installation
Device with standard OBDII socket
4
、
SMS commands and instructions:
Send SMS command from user’s SIM card number to the SIM card number which inside the
GPS device.
The commands in the following SMS command list are in English input format, and the letters
are case-sensitive according to the instruction requirements.
Common commands
SMS command format
Device reply
Check setup
CXZT
Version, ID, IP, etc…
Set admin number
admin123456 15012404563
Admin ok
Set new password
pwd123456 654321
Password reset okay.
Device restart
CQ
CQ OK
Restore factory settings
FORMAT
FORMAT OK
Revise APN
NAPN=cmnet,,
APN OK
Over speed alarm
SZCS#SPEED=120
SETOK:SPEED=90
5
、
App
Search GPSPOS at Appstore
Search POSGPS at Google Play