unios Spectrum SPIKE LIGHT User manual

SPIKE LIGHT
Power
6 Watts
unios.com
Page 1/4
Spectrum
unios.com
Page 4/4
Spectrum 6W
SPEC0600
Base
Codes
Edition 23.7.20 | Product design and technical data may be subject to changeEdition 23.7.20 | Product design and technical data may be subject to change
Install Person/s
1x
Sizing Variations
Material
Aluminium
IP Rating
65
Parts
Class III
24V DC
A
C
B
All measurements are in millimetres.
SPEC0600
Product CodeA
600
B
160
C
50
Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1 2
2x Heatshrink
SolderJoiners
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Corrosion Protection
It is important to notethat care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applicationson
the luminaire or chemical contact via installationwill
cause corrosionof the surface of the luminaire and will
void the warranty.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.

Page 2/4 unios.com Page 3/4
Edition 23.7.20 | Product design and technical data may be subject to change
Wiring
ON
OFF
Driver Selection
SPEC0600
Output
Power
Forward
Voltage
Product Code
6W 24V DC
AC
240V
Power Source
SELV
L
DRIVER
LED
N
1 2
3
Strip 7mm 7mm
HeatHeat until tin melts
2
1
Dimming
For dimming capabilities, luminaire must be paired with
dimmable driver. Please refer to driver's instructions for
pairing of suitable systems.