UPC 2231A User manual

UPC #2231A 3-Tier 48" Break Resistant PETG Card Rack
Revised 06/19/14 Page 1 of 2
PARTS LIST
ASSEMBLY
G
F
F
PART Quantity Reference
Screw Post 3A
Slatwall Adapters 3B
#8 - 32 Hex Nuts 3C
Plastic Wall Toggler 3D
Philips Head Screws 3E
PARTS BAG
PART Quantity Reference
Rack 1F
Divider 8 G
TOOLS REQUIRED: Flathead Screwdriver (Slatwall)
Drill with 3/8” Drywall Bit & Phillips Screwdriver (Drywall)
AB
C
E
D
ASSEMBLY INSTRUCTIONS
Align hole in Slatwall Adapter (B) with
back side of hole in Rack (F). Prongs extend
back toward Slatwall and up. Attach using
Screw Post (A) from front and Nut (C)
on back.
Slatwall Assembly
1
Insert Divider (G) into
Rack (F).
2
G
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
C
B
A
C
B
A
C
B
A

D
D
D
E
E
F
F
Insert Divider (G) into
Rack (F).
3
E
G
Page 2 of 2
Place Rack (F) against Toggler
and insert Screw (E),
tightening until secure.
12
Drywall Assembly
WALLWALL
WALLWALL
D
E
D
F
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
Determine position on wall
and drill 3/8" holes using drill and
3/8” drywall bit. Squeeze
Wall Toggler (D) flat and
insert into hole. Tap flange
flush with wall.