USAVision UA-B580F3 User manual

Before attempting to connect or operate this product,
please read these instructions carefully and save this manual forfuture use. UVSCAM-UM-C
Quick Start Guide
IP Cameras
UA-B580F3
UA-R500F2
UA-R560F2
UA-R580F2
UA-R800F2

© 2022 USAVision, Inc. All rights reserved.
Under the copyright laws, this manual may not be copied, in whole or in part, without
the written consent of USAVision.
Every effort has been made to ensure that the information in this manual is accurate.
USAVision makes no expressed or implied warranty of any kind and assumes no
responsibility for errors or omissions. No liability is assumed for incidental or
consequential damages arising from the use of the information or products contained
herein. Features and specifications are subject to change without notice.
USA Vision Systems Inc.
9301 Irvine Blvd,
Irvine, CA 92618, USA
Tel: [phone]
Fax: [phone]
https://www.geovision.com.tw/us/
March 2022
Scan the following QR codes for product warranty and technical support policy:
[Warranty] [Technical Support Policy]

i
Contents
1. Camera Connection Diagram.............................................................................1
2. Camera Overview................................................................................................2
3. Installation...........................................................................................................4

1
1. Camera Connection Diagram
Attention: There are two connection modes:
1. For non-PoE router, please connect the camera by a PoE switch or a PoE injector.
2. For a POE NVR, please connect the camera directly to the POE NVR, then follow the
below steps.

2
2. Camera Overview
2.1 UA-R500F2 / UA-R560F2 / UA-R580F2 / UA-R800F2
1
2
4
3
4
5
67
No.
Description
No.
Description
1
IR LED x 2 (For UA-R500F2 / R560F2
/ R800F2)
5
Warm LED x 2 (For UA-R580F2)
2
Built-in microphone (For UA-R500F2 /
R560F2 / R800F2)
6
Default button
3
IR LED x 2 (For UA-R580F2)
7
SD card slot
4
Built-in microphone (For UA-R580F2)
Note: Press the default button for 15 seconds to reboot the camera.

3
2.2 UA-B580F3
4
1
2
4
34
No.
Description
1
IR LED x 2
2
Warm LED x 2
3
Default button
4
SD card slot
Note: Press the default button for 15 seconds to reboot the camera.

4
3. Installation
Bullet Camera Installation
Ceiling Mounting
1. Insert three expansion bolts in place into the ceiling and fix the equipment with three
mounting screws.
2. Completion of installation.

5
Dome Camera Installation
Ceiling Mounting
1. Paste the sticker in place at the proper position as selected.
2. Remove the collar off the camera by rotating it down.

6
3. Fix the pedestal by drilling locking holes around the sticker and inserting three expansion
bolts into the holes and fastening it with three locking screws.
4. Mount the collar back by rotating it up.

7
5. Adjust it to an appropriate angle.
6. Completion of installation.