UTICOR PMD 200 User manual

PMD 200
Programmable Message Display
User Manual

PMD 200 Programmable Message Display
WARNING
In the application of UTICOR Technology, LP programmable control devices, you should consider
them components. Therefore, provisions other than the programmable control device must be taken
to protect personnel in the event of a programmable control device malfunction. Programmable
control devices should not be used as stand-alone protection in any application. Unless proper
safeguards are used, unwanted start-ups could result in equipment damage or personal injury. If
programmable controllers are used with operator interface and like devices, this hazard should be of
primary importance. The operator should be made aware of this hazard and appropriate precautions
should be taken.
In addition, consideration should be given to the use of an emergency stop function that is independent
of the programmable controller.
The diagrams and examples in this user’s manual are included for illustrative purposes only. UTICOR
Technology, LP cannot assume responsibility or liability for actual use based on the diagrams and
examples.
IMPORTANT: Static messages that remain on the display for an extended period of time may
cause uneven illumination of the display’s dot matrix grid. This is caused by the inherent
properties of all vacuum fluorescent display technology. To avoid uneven character display,
use the DISPLAY SAVER TIME-OUT feature described in the manual. Do not leave the same
message on the display for indefinite periods of time.
Trademarks
This publication may contain references to products produced and/or offered by other companies. The product
and company names may be trademarked and are the sole property of their respective owners. UTICOR
Technology, L. P. disclaims any proprietary interest in the marks and names of others.
1st printing —06/03 Manual Number 79702-9
©Copyright 1986-2003, UTICOR Technology, L.P.
All Rights Reserved
No part of this manual shall be copied, reproduced, or transmitted in any way without the prior written consent of UTICOR Technol-
ogy, L.P. UTICOR Technology, L.P. retains the exclusive rights to all information included in this document.
MANUFACTURED and MARKETED by UTICOR TECHNOLOGY, L. P.
4140 Utica Ridge Rd. •Bettendorf, IA 52722-1327
Phone: 1-563-359-7501 •Fax: 1-563-359-9094 •www.UTICOR.net
PMD 200


















Other UTICOR Monitor manuals