Use & Care
Manual
L I G H T W E I G H T E L E C T R I C I R O N
OPERATION DRY IRONING
Keep iron on heel rest insert plug pin in wall socket &
make mains supply ‘ON’.
Set Temprature regulating knob for desired fabric
(./../...) & Indicating light will glow. Wait for indicating
light to go off .
This Indicates that iron is ready for ironing since desired
temperature is achieved.
* Read this garment lable and follow the manufacturer’s
ironing* instruction that are often shown by symbols
similar to the following
Please ensure that while replacing power supply cord an
insulation sleeve of fiber glass or equivalent material has
to be used over & above cabel insulation.
If the supply cord is damaged, it must be replaced by
manufacturer, its service agent or similarly qualified
person in order to avoid hazard.
Before cleaning Remove the Plug from wall socket and
allow iron to cool down Suffi ciently.
One can wipe it with damp cloth and then dry cloth.
Do not use thinner /solvent for cleaning.
Check regularly whether mains cord is safe to use.
POWER SUPPLY : 230 v 50 hz AC with Earthing
WATTAGE : 750 watts
TEMPERATURE : Manually adjustable control thermostate
VALLABH
Iron has been manufactured under stringent quality
parameters & make use of latest manufacturing technology.
VALLABH
Iron has been designed keeping in view ISI standards .
VALLABH
Iron is most elegant, safe, economical & Backed by
eff i cient after sales services through its dealers & Distributors.
Features
Adjustable thermostatic control.
Flexible & swiveling cord grommet for ease of use & safety.
Indicating lamp for heater on/off display.
Aluminium sole plate.
Thermal fuse for added safety.
Do’s & Dont’s
Read instructions carefully before operating your iron.
Connect the iron to plug point only specified on rating lable/
manual.
The iron should never be left unattended while it is connected
to the mains supply.
Keep iron out of the reach of children.
Don’t allow the cord to touch hot sole plate or any hot surface.
Take care for arranging cord while in use so that it may not be
pulled.
Always Place the iron with its back ( vertical ) on firm flat
surface during ironing & after use .
To protect against electric Shock do not immerse iron in water
or any liquid , also air may damage the electrical circuit.
Do not operate the iron with a damaged cord or if the iron has
been dropped or damaged. Get it examined/repaired by autho-
rized dealer. Do not try to dissemble it for any reason.
Don’t operate another high wattage appliance on the same
circuit.
Ensure earthing in supply socket for safety.
Use iron for its intended use & domestic purpose only .
Avoid use of extensions/extension boards as this may be
hazardous.
Synthetic, Nylon MIN MIN
I
II
III
MAX
MAX
Silk, Polyster, Rayon
Wool
Cotton
Linen
SAFETY
IS: 302-2-3
CM/L 9139480
Care Maintenance
Note
IS: 366
CM/L 9140566
