WIFIR3
V. 01 – 22/08/2013 6 ©Velleman nv
7.1 Connect your router to the repeater
During setup, it is recommended to use a wired connection with the
included RJ-45 network cable.
Once setup is done, you can use the repeater through Wi-Fi.
To connect the router, you need to
•configure network settings on your computer
•configure the repeater in the web management tool
•reset your computer’s network settings
•connect the repeater to your computer
7.2 Configure network settings on your computer
The repeater has a fixed IP address. To be able to access the
repeater during setup, you first need to configure your computer’s
network settings as follows:
1. On your computer, click the Start button and choose
Control Panel > Network & Sharing Center.
2. In the list of networks, click on your network and then click the
Properties button.
3. In the list, select Internet Protocol Version 4 (TCP/IPv4),
then click the Properties button.
4. In the Properties window, select Use the Following
IP Address.
oIn the IP Addressbox, type 192.168.10.x where ‘x’ is a
number from 2 to 254.
