vendon vBox2 User manual
vBox2 s m croprocessor dr ven IoT dev ce for data collect on from vend ng mach ne or coee
mach ne components us ng var ous standard sed protocols. vBox2 transm ts collected data over
GPRS network to Vendon server gateway. Dev ce rmware s preloaded and managed centrally
us ng Over-TheA r technology. vBox2 supports user (operator) nteract on v a mult - purpose
congurable funct on button. User operat ons are conrmed w th sound s gnals. Dev ce status
nd cat on LEDs are located on front panel.
1 pcs cellular antenna
2
Reset button
Function button
Power, online and
operation status LEDs
USB Mini-B connector
Cellular antenna
connector
3
USB Mini-B connector - for manual rmware and protocol
upload
Blinking slow) - preparing cellular modem on vBox2 start up
ON - modem is connected and communicates with the server online).
Red - modem status
OFF - vBox2 device is o.
Blinking fast) - modem is ON, and is exchanging data with the server online, processing).
4
(non-condensing)
+5° to +50°C
5
Do not dissemble o modify vBox2 device. Dismantling of the vBox2 (dismantling of the plastic
casing o inte vention in the PC boa d) can aect device’s functioning o damage device
Risk of explosion if batte y is eplaced by an inco ect type. Dispose of used batte ies
acco ding to the inst uctions.
Avoid liquid penet ation into vBox2 device
Install o elocate vBox2 device only when disconnected f om the powe supply
Only cables p ovided by Vendon must be used.
Do not alte the cables p ovided with the vBox2
A visual inspection of the vBox2 device must be pe fo med on a egula basis
Discontinue usage if the device looks defo med, b oken o swollen.
Built-in echa gable Li-Po batte y 3.7V 560mAh
The batte y withstands up to 300 full cha ge and discha ge cycles unde no mal wo king
conditions (tempe atu es 25°C ± 0.5°C). The cycle life is the cycle times when the discha ge
capacity is about 80% of the ated capacity.
The batte y wa anty is aligned with the vBox2 wa anty and it is 1 yea
Only Vendon autho ised and t ained pe sonnel may emove and change the batte y.
The batte y must be eplaced only by a batte y custom made fo Vendon.
N
eve attempt to sho t-ci cuit the device o the batte y
The device and batte y must be ecycled and disposed of p ope ly.
Disposal. Do not dispose vBox2 device with household waste.
Do not dispose of the batte y o the device in
e.
If the device is not used fo a long time, fully echa ge the device eve y half a yea .
S
to e the
device in a cool and d y place
9-24V AC 400-200mA
vBox2 powe supply is p ovided by connection C1 (see vBox2 components). Use only powe sou ce
of type “PS1” with inte nal powe limit up to 15W. Unit shall be supplied f om LPS (Limited Powe
Sou ce). Using a se ies fuse is ecomended.
6
FCC ID: 2AZE3-VP-B244G
Contains T ansmitte Module FCC ID: 2AJYU-8VC0001
NOTE: This device complies with pa t 15 of the FCC Rules. Ope ation is subject to the following two
conditions: (1) This device may not cause ha mful inte fe ence, and (2) this device must accept any
inte fe ence eceived, including inte fe ence that may cause undesi ed ope ation
Changes o modications not exp essly app oved by the pa ty esponsible fo compliance could
void the use ’s autho ity to ope ate this equipment.
Contains:
7
8
Attach an antenna. For better network reception place
the antenna outside of the vending machine.
www.vendon.net
Krasta 44, Riga, LV-1003, Latvia
+371 2866 9995
vendon@vendon.net
