Venstar ColorTouch T5800 Use and care manual

VENSTAR
CALIBRATION GUIDE
Master Calibration
Procedure Guide

Models: T5800, T5900, T6800, T6900, T7800, T7850, T7900, T8800, T8850, T8900
1) Press the MENU button
2) Press the DOWN arrow key
3) Press the SETTINGS button
4) Press the INSTALLATION SETTINGS button
5) Press the DOWN arrow key repeatedly to reveal the SENSOR
SETTINGS button
5) Press the SENSOR SETTINGS button
6) Press the CALIBRATE SENSORS button
7) Press the THERMOSTAT button
8) Use the UP or DOWN arrow keys to calibrate the sensor +/- 7°F
9) Press the HOME button to return to normal operation
ColorTouch Thermostats
Models: T1700, T1800, T1900, T2700, T2800, T2900
1) Press and hold the MODE button
2) While holding MODE, press and hold the FAN
until all the icons appear on the display
3) Press the UP and DOWN arrow keys at the same
time, twice
4) Press the UP or DOWN arrow keys to calibrate the sensor +/- 3°F
5) Press the MODE button one or more times to return to normal
operation
Slimline Thermostats
2

Model: T1100RF / T1100REC
1) Press and hold the MODE button
2) While holding MODE, press and hold the
DOWN arrow key until all the icons appear
on the display
3) Press the MODE button twice
4) Press the UP or DOWN arrow keys to calibrate the sensor +/- 3°F
5) Press the MODE button once to return to normal operation
Wireless Thermostat
Models: T1035 and T1045
1) Slide the PROGRAM switch to the SET
position
2) Press and hold the NEXT button until the
deadband adjustment screen appears
3) Press the NEXT button once
4) Press and hold the NEXT button until all of the icons appear
5) Press the NEXT button once
6) Press the UP or DOWN arrow keys to calibrate the sensor +/- 3°F
7) Press the NEXT button once
8) Slide the PROGRAM switch to the RUN or OFF position to return
to normal operation
Programmable Value Thermostats
3

Models: T1010, T1050, T1075, T1070, T1000FS, T1100FS
1) Press and hold the MODE button
2) While holding MODE, press and hold the
DOWN arrow key until all the icons appear
on the display
3) Press the MODE button once
4) Press the UP or DOWN arrow keys to calibrate
the sensor +/- 3°F
5) Press the MODE button once to return to
normal operation
Super-T2 and FlatStats
4