VENTRA VLCD-7 User manual
Warning: Install product only when vehicle is safely parked and Power is
OFF. View and access the monitor only when safe to do so. Do not operate
monitor while driving
Installaon Guide
1. Determine the locaon of the mounng posion, clean with damp towel
2. Securely affix mounng bracket to vehicle
3. Affix monitor to the mounng bracket, determine angle and ghten with
angle screw
4. Connect Power cable to the monitor, use electrical tape if necessary
5. Connect RCA video cable to source, use electrical tape if necessary. If
connecng to 2 video input, an addional RCA cable is required
6. If connecng VLCD-7 trigger wire (Green wire) to reverse signal, connect
camera 2 to CH 2 video input. Ensure the green wire is connected to the
reverse or turn signal of vehicle
VLCD-7 Operaon
1. Press Menu key to Enter or Exit Menu
2. Press ( + ) or ( - ) to navigate menu. Press ( + ) or ( - ) to change seng
Operaon Guide:
1. VLCD-7 monitor supports dual video input. If only 1 camera is connected,
that camera will be primary, regardless of which input it is connected to
2. If connecng 2 cameras,
Input 1 = Primary Camera
Input 2 = Secondary Camera
3. To switch camera view, Press V1 / V2 to switch to second camera, Or if
the secondary camera was powered on / triggered by a switch (i.e. turn
signal). Monitor will auto revert back to the primary camera aer a few
seconds.
VLCD-7 (V2) 7” TFT LCD Monitor
Ventra Technology Inc. Covina, CA. USA www.ventrainc.com [email protected] Tel: 888 418 3833 Version 03 2020
Thank you for purchasing Ventra product. Before operang or
installaon, please read and follow the manual.
23 F - 140 F ( -5 C – 60 C)
5 F - 149 F ( -15 C – 65 C）
Dual Video Input ( V1 / V2 )
Normal or Mirror image
Parts included:
Monitor x 1
RCA video cable x 1
Power cable x 1
Monitor stand x 1
Remote control x 1
Screws and washer
Angle adjustment screws
1 2 3 4 5 6 7
VLCD-7 (V2) 7” TFT LCD Monitor
Down ( - )
Up ( + )
Ventra Technology Inc. Covina, CA. USA www.ventrainc.com [email protected] Tel: 888 418 3833 Version 03 2020
Table of contents
