Vera Vistacam 700 Instructions for use

Install and Setup Vistacam 700
This guide will teach you how to:
•Mount and install your Vistacam 700 camera
•Setup your Vistacam 700 wirelessly

Wireless Setup
1. Firmly press the blue WPS button once, located on the back of the VistaCam 700
2. The network LED will blink amber, indicating that the pairing process has started On
the Vera unit, press the Select button until the Wi-Fi LED blinks Press the Sync button to
confirm the selection and go to WPS mode.
3. After a minute, the green power LED on the back of the camera will be solid and the
network LED will begin blinking green

NOTE: The LED will first turn on and then start blinking. It will blink during startup, which
will take about a minute. After the startup is completed, the green LED should remain
ON.
Mounting and Installation
NOTE: Please ensure that the Wireless Full HD IP Camera is configured and added to the
network before mounting it.
1. Identify the location for mounting the Vistacam 700 Camera
2. Place the camera in the desired position on the wall/ceiling. Screw the two screws into
the wall through the holes of the stand
3. Firmly connect the AC Power Adapter to the VistaCam 700 Power Connection and
then plug it into an AC outlet.