Versa Drives SUPERFAN A1 User manual

INDIA'S FIRST
SUPER EFFICIENT FAN
USER MANUAL
Congratulations for becoming an owner of the
SUPERFAN.Youhavemadeanexcellentchoiceand
wehopeyouenjoyallitscapabilities.
This user manual explains how to use SUPERFAN.
Please read this manual before operating your
Superfan and keep it for your future reference.
ThankYou.
VERSADRIVESPRIVATELIMITED.
LIST OF FAN PARTS
V1.1Mar,2013,
Revision: Air delivery and power specifications changed in
section1.2andthemountingheightfromceilingis mentioned.
PATENTPENDING.
Unpack the carton of Superfan and check whether
youhavethefollowingitems.
1.Downrod
2.Topcanopy
3.Bottomcanopy
4.Shacklekittofixthedownrodwithceilinghook
5.Kittofixthedownrodwithfanmotor
6.Fanmotorwithleaffixingscrews
7. Remote (6 key or 9 key remote based on the
modelofSuperfan)
8.Leaf–3No’s.
5
4
1
2
TM 3
TM
8
67
TM
BEFORE INSTALLING AND OPERATING YOUR
SUPERFAN, PLEASE READ SAFETY
INSTRUCTIONSCAREFULLY.
• Before installing or cleaning the fan, switch off
the power at the electricity panel and the
associatedwallswitchlocation
• Lock the electricity panel or securely fasten a
warningdevice, suchasa tagtopreventpower
frombeingswitchedonaccidentally
• Wirings must be done by qualified electricians
only
SAFETY INSTRUCTIONS
• The fan must be mounted at minimum height
of 1 foot from ceiling and 7 feet from the
floortopreventaccidental contactwiththe fan
leaves.
• Do not bend the leaves while installing or
cleaning.
• Store the remote battery in a place where
children cannot reach. If a child accidentally
swallow’s the battery consult the doctor
immediately.
• Disposethe batteryin aproper manner. Donot
disposeitinfire.
• Do not short or disassemble the remote
battery.
SuperfanisIndia’sfirst super-efficientfan whichis
designedtoconsumelessamountofenergyeven
athighspeed. Henceitwill reduce yourelectricity
bill.
1.1. INTRODUCTION:
1.2. SPECIFICATIONS
SPECIFICATIONS ARE SUBJECT TO CHANGE
WITHOUTNOTICE
1.3. FEATURES
• Energy saving, more than 50% savings, lower
electricitybill.
• Sensor-lessdesignformorereliability.
• Green manufacturing (ROHS electronics, VOC free
paint,Greenpacking).
• Remote control for speed command, no regulator
needed,savespaceonswitchboard.
• Indicationofremoteoperation.
• Highspeed,highvolumeofair.
• Consistent speed in low voltage and varying
voltages.
• Powerfactorbetterthan0.9andmoreairperwatt.
• Lessheatgeneratedbyfanmotor,cooloperation.
• No extra noise during operation from inverter
supply.
• Morehoursofoperationwithinverter.
• 2yearsofwarranty.
SUPERFAN CAN BE POWERED ON/OFF BY
USINGASIMPLEWALLSWITCH
Please do not connect any regulator to
yourSuperfan
Phase &
Neutral
wires
Fig 4
Terminal
Block
Fig 3
Washer
and nut
Cotter pin
Fig 2
Shaft
Slit end
Down rod
Fig 1
1. Take out the fan motor and place it
gentlyonacleanandsoftsurface. 2.Fixtheslitend
of the downrod onto the shaft using bolt, washer,
spring washer, and nuts. Ensure that it is fully
tightened 3. Then put the cotter pin
into the bolt hole and bend its two ends apart, to
lock 4. Connect two wires (for phase
(red wire) and neutral (black wire) connections) on
theothersideoftheterminalblock.Theninsertthe
wires from the bottom side of the down rod to the
top side 5. Insert the bottom canopy
(Top and bottom canopies are identified with
[Ref: Fig 1]
[Ref: Fig 2].
[Ref: Fig 3].
[Ref: Fig 4].
1.4. INSTALLATION INSTRUCTION
THERE SHOULD BE NO OBSTRUCTIONS
FOR THE FAN TO ROTATE AND OBJECTS
(LIKE WALL, OR POST) SHOULD BE AT
LEAST 2 FEET (~61 CM) AWAY FROM THE
TIPOFTHEFANLEAVES
Before making/removing the
connections in the ceiling rose, please
switchoffthepower.
orientation of Superfan logo) from the topside of
the downrod. Insert the top canopy in an inverted
manner 6. Fix the shackle kit in the
ceilinghook 7. Fixthe fanassembly in
the shackle using bolt, washer, spring washer, nuts
8. Then tighten the nuts. Put the
cotter pin into the bolt hole and bend its two ends
apart to lock. 9. Connect the phase and neutral
wires coming out from the downrod tothe ceiling
roseasshowninthe .Connect (Green/yellow)
earthwireto the screw marked as" "on the
[Ref: Fig 5].
[Ref: Fig 6].
[Ref: Fig 7].
Fig8
Parameters
Input Voltage
(Vac)
Rated frequency
(Hz)
Span (mm)
Typical
Speed (rpm)
Typical Input
power (Watts)
Power factor
Air delivery
3
(m /min)
Speed control
Remote battery
160 to 265
48 to 52
1200
350
33
0.94
220
Super T2
Lithium coin battery 3V 165mAh
1200
385
33
0.94
230
Super T1
1400
275
38
0.94
270
Values
Super
A1 Super X1 Super V1
1357
2468

Remotecontroller keys:On/Off
Description/ Function: To Switch off the running
fan / To Switch on the fan which was stopped using
remote.
Indication: Glows steadily / Flash depends on
previouslysetspeed.
Noisy operation
1. Bottom
canopy
touching the
top cover of
the fan.
1.Adjust the
canopy so
that it does
not touch the
top cover
2. Fan leaves
are not fixed
tightly
2. Tighten the
mounting
screws of the
leaf
Excessive
shaking
1.Down rod is
not fitted
tightly with
shaft
1. Tighten the
screws and
bolts
connected to
the down rod.
Power is on but
Fan does not
rotate and also
no indications of
Superfan
Problem Problem
Cause Solution
1. Circuit
breaker
tripped.
1. Reset the
breaker
2. Loose
connection of
wires
2. Tighten the
wire
connections
Remote does
not work
1. Remote
battery drain 1. Replace the
old remote
battery with
new battery
(lithium coin
cell battery
CR2025 or
equivalent)
Remote does
not work even
with new battery
1. Remote
problem 1. Replace the old remote
by new
remote.
Fig 5
Top
canopy
Bottom
canopy
TM
TM
Fig 6
FRONT
SIDE VIEW
Ceiling
hook
Fig 7 Fig 8
Wall switch
L
N
Tighten up
the Screws
Fig 9
shacklekit. 10.Removethe Leaffixing screwsfrom
the motor and then place the leaves on each side
of the motor and fix it by using screws and spring
washers While mounting the leaves
take care not to bend the leaf. 11. Adjust the
canopies such that top canopy covers the shackle
assembly near ceiling and bottom canopy covers
the terminal block connector of the fan. 12.
Bottom canopy should not touch the fan motor.
Otherwiserubbingnoisewillcome.
[Ref: Fig 9].
1. After ensuring that the fan is fixed properly and
there is no obstruction for its rotation, switch on
the fan using the wall switch connected to the fan.
2. Now the indicator on the fan
will glow. 3.Then press On/Off key ( ) of remote.
The fan will run at the speed at which it was
runningpreviously.4. Pleasepullouttheinsulation
sheet before using the remote.
5.Speedcanbechangedbyusingtheremote.
(shown in Fig 10)
[Ref: Fig 10A]
1.5. OPERATING INSTRUCTION
Fig 10
Indicator for
remote
operation
Fig 10A
Insulation
sheet
6. To operate your Superfan with remote, press the
remote keys while pointing remote towards the
indicator on the fan. 7. If Superfan senses a key
pressed in remote, the indicator will flash to indicate
the speed command. 8. Super X1 and
Super V1 model can be operated using
6 key remote (Super T1) which has one On/Off key
and5Speedkeys.
[Ref: Fig 11]
[Ref: Fig 12]
Remotecontroller keys:1to5
Description/ Function: To run the fan at Speed 1,2
to5respectively.
Indication: Flash once, twice to five times
respectively.
9. Super A1 model can be operated
using a special 9 key remote (Super T2). 10. In 9 key
remote, three more extra keys are provided for fine
controlofspeedand tosimulatenatural breezeofair
dependingontherunningspeed.
Remote controller keys: up / down (Fine tuning of
speed).
Description/ Function: To increase the speed while
running/Todecreasethespeedwhilerunning
Indication: One short flash for each Increase(4 to 5
rpm)/Oneshortflashforeachdecrease(4to5rpm).
[Ref: Fig 13]
Fig 11: Super X1
TM
TM
TM
IFYOULOSETHEREMOTE!
Case (1) - If you lose the remote when the fan was
running or after the fanwas switchedoffusingthe
wallswitch,youcanoperatethefanatsamespeedby
turningthewallswitchoffandthenon.
Case (2) - If you lose the remote after the fan was
stopped using the remote, you should turn the wall
switchoffandonforfivetimestorunthefanatspeed
3. After this till you buy a new remote you can
operatethefanasmentionedincase(1).
1.6. MAINTENANCE INSTRUCTION
Beforestartingany maintenanceor service
activity,ensurethatthefanispoweredoff.
1. Clean the fan leaves and motor using a soft wet
cloth at regular intervals. Do not use cleaning
solvent. 2. While cleaning, take care not to bend the
blades. 3. Check the tightness of the bolts / fixing
screws. To replace the remote battery (CR2025) refer
the picture which is shown at the backside
ofyourSuperfanremote.
(Fig 10A)
REPLACE THE BATTERY ONLY WITH THE
SAMEOREQUIVALENTTYPE.
1.7. TROUBLE SHOOTING GUIDELINES
Please turn off the power before
handlingyourfan.
IF YOU HAVE TRIED THE ABOVE
MENTIONED TROUBLESHOOTING
INSTRUCTIONS AND IF THE PROBLEM
PERSISTS STILL PLEASE CONTACT US FOR
SERVICING.
Contactdetails:
TollfreeNo:180042578737
MobileNo:9489078737
E-mail:[email protected]
Web:http://www.superfan.in
Remotecontroller keys:breezekey
Description/ Function: Simulate natural breeze
dependingontherunningspeed.
Indication:Oneshortflashforreceivingcommand.
11. When you use fine control, at certain speeds you
mighthear ahummingsound becauseofresonance.
You can avoid this by increasing or decreasing the
speed. 12. In the 9 key remote the three extra keys (
up , down, breeze) will work only when the fan is
alreadyrunningandalsothesekeyswillworkonlyfor
Super A1 model. 13. Indicator will not flash when
input power to the fan is off and also when the fan is
runningcontinuouslyinsamespeed.
9 11 13 15
10 12 14 16
Fig 12: Super V1
Fig 13: Super A1