VESTEL GAIA Garden Spot Light 2.5w User manual

GAIA Garden Spot L�ght
User Manual
NO
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
1
1
1
1
1
3
3
1
1
2
2
1
1
4
1
1
1
1
1
1
2
DEFINITION
INSTALLATION INSTRUCTIONS
SAFETY WARNINGS
1- Garden Spot L�ght
Blue (-)
Brown (+)
PRODUCT DRAWING
PACKAGE CONTENT
F�gure. 1
F�gure.2
Do not use the dev�ce �f �t �s dropped or exposed to a shock. R�sk of �mproper
operat�on.
If the dev�ce �s turn�ng off or not operat�ng properly, never attempt to repa�r the
dev�ce by yourself. Please contact author�zed serv�ce.
1- Install the �nd�cated bolt �nto the hole �n arrow d�rect�on (F�gure.2)
2- Mount the washer �nd�cated by c�rcular arrow w�th bolt connect�on.
22 1
PIECES
METAL CAP
FRAME
GLASS
BODY - GLASS GASKET
LENS RETAINER LENS
SCREW SK FNI YFMB 2.9*5.2
PCB
BODY
M5*10 SCREW
DRIVER CARD
DRIVER CARD COVER
GASKET
DRIVER CARD COVER
M4*10 IMBUS SCREW
M16*1.5 UNION
CABLE
M6 SPRING WASHER
RETAINER
PILE
M6*15 SCREW
M5 SPRING WASHER
M4*4 STAY BOLT
Do not look d�rectly at the product wh�le �t �s �n operat�on. Strong l�ght can cause
v�sual problems.
Never cover the dev�ce w�th paper of clothes or place the dev�ce close to
flammable mater�als, otherw�se can cause to f�re or the dev�ce can operate
�mproperly.
Keep a d�stance between the dev�ce and the �tem to be �llum�nated. If the d�stance
�s very l�ttle, �t can cause d�scolourat�on or deformat�on of the �tem or f�re.
Do not use the dev�ce for any dut�es except for �llum�nat�ng.
Product. Compl�es w�th the AEEE Regulat�on.
CAUTION
Do not clean the surface of the product w�th flammable mater�als such as alcohol,
gasol�ne or acetone.
Do not use the dev�ce �n an atmosphere of corros�ve gasses.
When �nstall�ng the dev�ce, make sure the power supply �s off.
Ma�ns connect�ons should be done by techn�cal serv�ce personnel. For the ma�ns
connect�ons, all �nstallat�ons of connectors, term�nals, etc. should be �n accordance
to the cable cross sect�on and local w�r�ng regulat�ons. Author�zed serv�ce
personnel �s respons�ble for �nstall�ng requ�red protect�ve dev�ces such as c�rcu�t
breaker and fuse box, ma�nta�n�ng requ�red �nsulat�on clearances between the
condu�ts, and tak�ng necessary precaut�ons aga�nst electr�cal shock that could be
r�s�ng because
of these connect�ons. If outer elast�c cable or cord gets damaged, �t should be
replaced by new ones. Th�s task can only be done by techn�cal serv�ce or
manufacturer.
Surface of the product can be hot when operat�ng. Do not touch the product, unless
turn�ng �ts power off and lett�ng to cool down.
Cable requ�red for connect�ng power supply to �nput term�nals must have m�n�mum
sect�on of 2x1mm² qual�f�ed as H05RN-F.

.
Product �s des�gned as Class III
Product operates on 30V DC constant voltage. Values of current requ�red to be
used depend�ng on product power values are prov�ded �n table-1.
CONNECTION SCHEMATICS
GAIA Garden Spot L�ght 5w
GAIA Garden Spot Light 15w
Connect�on �s made v�a use of appropr�ate ter�mak* w�th pos�t�ve (+) cable from
constant voltage power supply to brown term�nal of product as �nd�cated �n f�gure-5,
negat�ve (-) cable to blue term�nal of the product.
3- Mount the f�x�ng sk�d w�th bolt and washer �n up arrow d�rect�on.
4- Fasten the f�x�ng sk�d to a flat surface �n the down arrow d�rect�on. (F�gure.3)
5- Cable connect�ons are made �n the area �nd�cated by arrow.
Brown (+)
Blue (-)
Brown (+)
Blue (-)
F�gure.5
F�gure.4
F�gure.3
Table-1
Product Name Power Voltage (Vdc)
GAIA Garden Spot L�ght 2.5w 30V
30V
30V
30VGAIA Garden Spot Light 22w
Current (mA)
90mA ± 10%
170mA ± 10%
500mA ± 10%
750mA ± 10%
Table-2
LOAD Sect�onal Area
3A
3A
3A
1.0 mm²
1.5 mm²
2.5 mm²
D�stance (Meter)
55
80
135
Vestel Elektron�k Sanay� ve T�caret A.Ş.
Organ�ze Sanay� Bölges� 45030
Man�sa - Türk�ye
Power supply to be used for product must be approved as per standards IEC/EN
61347, En55015 and EN 61547. Power supply must prov�de protect�on level IP66
as m�n�mum and output voltage shouldn't exceed SELV range of 30V±5%.
Connector to be used at all connect�ons of the product must be approved as per
standards IEC/EN 60998, prov�de m�n�mum protect�on level IP66, double �nsulated,
valued at 16A/250V, comply�ng w�th sect�on of 0,5mm²-2.5mm² and allow screw
�nstallat�on. Conduct�ve term�nals of the cable from power supply must be have
STK comply�ng w�th screw connector.
Allowable voltage drop for the product �s l�m�ted to 3.5V.
Accord�ngly the d�stance between power supply and product must be max�mum 55
meters depend�ng on cable sect�on area**.
** mm² sect�onal area of extens�on cable must be selected from Table 2 accord�ng
to amount of load at the end of cable and cons�der�ng the max�mum voltage drop of
cable.